How to open longrange fec function?

RE: How to open longrange fec function?

Август — Thu, 07 Apr 2022 08:46:46 GMT

Thank you I will check it.

RE: How to open longrange fec function?

Susheel Nuguru — Thu, 07 Apr 2022 07:26:13 GMT

That time shown below is the time from "end to start"

That means that master is not sending anything during that time. If that period is less than supeprvision timeout and the obeys slave latency, then master is allowed to send packets with that delay. You need to find out why master is delaying that packet transfer that much (assuming that nRF chip is slave here)

RE: How to open longrange fec function?

Август — Mon, 04 Apr 2022 05:09:07 GMT

Thank you for your response,In the packets I grabbed, I don't see the extra bytes.

When I send a packet, mtu=247 will be followed by such a packet, what is this?

RE: How to open longrange fec function?

Susheel Nuguru — Fri, 01 Apr 2022 11:26:44 GMT

please note that every bit in the packet in in S8 Coded PHY is replicated 8 times taking the packet longer to transmit as compared to 1M PHY. Based on your connection interval, Is that what you are seeing?

RE: How to open longrange fec function?

Август — Tue, 29 Mar 2022 01:05:32 GMT

Thank you It's ok.

I found another problem, when I send a packet mtu=247 will be followed by such a packet. I didn't find it in Core_v5.0.pdf

RE: How to open longrange fec function?

Susheel Nuguru — Mon, 28 Mar 2022 18:15:20 GMT

Sorry for the delays, I could not look into this today and will come back to you mostly tomorrow. Thanks for your patience.