Configuration UARTE with nrf52805 for ESB - Part 2

[Ilary]

My previous ticket is closed. I would need, but still help with the configuration of the pins. I report my last post.

Hello,
I did some tests with the oscilloscope directly connected to pins 21 and 18 of the nrf52805.
The transmission on pin 18 by the Stm8l works perfectly. The problem I encounter now is that nrf52805 I have the pull up instruction on this pin

 nrf_gpio_cfg_input(PIN_RXD,GPIO_PIN_CNF_PULL_Pullup);

but nothing happens when oscilloscopes.

It could be that I get the pin definition wrong initially

 #define UARTE_BASE           0x40002000
  #define PORTA_UARTE          ((NRF_UARTE_Type *) UARTE_BASE )
  #define PIN_TXD            21
  #define PIN_RXD            18

or the pull up configuration of pin 18, set as input and pin 21 as output?

 nrf_gpio_cfg_input(PIN_RXD,GPIO_PIN_CNF_PULL_Pullup);
     nrf_gpio_cfg_output(PIN_TXD);

[Ilary]

still looking at the code of the main file.c modified by you I saw that the changes made concern only the speech of the CTS and RTS pins (which as I said we have not set by project), two libraries have been reactivated by me commented why? I saw that it was simply inserted in the handler of the uart the function esb_write_payload that as I said I will move later. the code I sent is the Tx project but it also acts as a receiver through uart the latter is the step that is giving me problems not receiving the data I send from the master