Configuration UARTE with nrf52805 for ESB - Part 2

[Ilary]

My previous ticket is closed. I would need, but still help with the configuration of the pins. I report my last post.

Hello,
I did some tests with the oscilloscope directly connected to pins 21 and 18 of the nrf52805.
The transmission on pin 18 by the Stm8l works perfectly. The problem I encounter now is that nrf52805 I have the pull up instruction on this pin

 nrf_gpio_cfg_input(PIN_RXD,GPIO_PIN_CNF_PULL_Pullup);

but nothing happens when oscilloscopes.

It could be that I get the pin definition wrong initially

 #define UARTE_BASE           0x40002000
  #define PORTA_UARTE          ((NRF_UARTE_Type *) UARTE_BASE )
  #define PIN_TXD            21
  #define PIN_RXD            18

or the pull up configuration of pin 18, set as input and pin 21 as output?

 nrf_gpio_cfg_input(PIN_RXD,GPIO_PIN_CNF_PULL_Pullup);
     nrf_gpio_cfg_output(PIN_TXD);

[Ilary]

after doing debug test with the new module I get the same problem I had before: communication error at the time when a value is sent from the master (my Stm8), I attach the screen with the watches active during debugging

trying to understand what problem there was I came to this : nrf_error.h that reports a No_Mem error as a value of 4. Searching on your online support I found this ticket: link which proposed a test: comment on the lines of error handling code to see what was happening. The problem arose after making this change to the code now I can no longer compile (see photo below)