Unable to flash nRF52840dk using west flash

RE: Unable to flash nRF52840dk using west flash

Sigurd Hellesvik — Wed, 20 Apr 2022 11:11:33 GMT

[quote user="noobsplzwin"]
With the above being said, if I choose not to update the firmware in J-link commander, select no in the picture below.
I am able to flash the program properly.[/quote]

Just to be clear:

So you do are able to use the nRF52840DK with this?

Regards,
Sigurd Hellesvik

RE: Unable to flash nRF52840dk using west flash

Huizhe Zheng — Wed, 20 Apr 2022 02:13:09 GMT

Sorry, the link in the above comment is not correct. The firmware I'm using is downloaded here, www.nordicsemi.com/.../J-Link-OB-SAM3U128-V2-NordicSemi-170724.bin

RE: Unable to flash nRF52840dk using west flash

Huizhe Zheng — Wed, 20 Apr 2022 02:04:40 GMT

Hi Sigurd,

Thanks for your response!
I am not sure where to find the version of the nRF52840DK. The sticker on the development board shows PCA10056 2.0.1 2021.10 683083855

It still shows the same error after. I am not sure why Jlink keeps recognizing the firmware downloaded from https://devzone.nordicsemi.com/f/nordic-q-a/8144/i-can-t-update-the-j-link-ob-firmware-nrf51-dk is compiled in 2017.

With the above being said, if I choose not to update the firmware in J-link commander, select no in the picture below.
I am able to flash the program properly.

RE: Unable to flash nRF52840dk using west flash

Sigurd Hellesvik — Tue, 19 Apr 2022 12:14:40 GMT

Hi Leo

Which version of the nRF52840DK do you have?

Are you able to enter bootloader mode again?
Try to update the bootloader once more the same way. Give the device a minute before re-powering it (plug it out and back in. Make sure no battery is connected) after the new bootloader has been programmed.

Does it still show the same error after?

Regards,
Sigurd Hellesvik

RE: Unable to flash nRF52840dk using west flash

Huizhe Zheng — Wed, 13 Apr 2022 15:16:39 GMT

devzone.nordicsemi.com/.../6470.log.log

Here is the error log for the reference