How to build Openthread CLI sample

RE: How to build Openthread CLI sample

jhc — Thu, 21 Jul 2022 07:41:08 GMT

I erased chip before downloading CLI firmware by mistake since I used an external jlink, so the original bootloader was erased.

I reconfigured the CLI sample with parameter CONFIG_BOARD_HAS_NRF5_BOOTLOADER=n.

RE: How to build Openthread CLI sample

Marte Myrvold — Thu, 21 Jul 2022 06:02:57 GMT

Hi,

That is great to hear! How did you manage to solve the problem?

Best regards,

Marte

RE: How to build Openthread CLI sample

jhc — Thu, 21 Jul 2022 02:59:06 GMT

GOT DONE!

RE: How to build Openthread CLI sample

jhc — Wed, 20 Jul 2022 06:05:11 GMT

For the dongle you must use USB as transport, which you have done by setting the correct configurations, so you will get logging through this, and not RTT. So you should connect to it using a terminal emulator instead, such as Tera Term or PuTTY.

But when I plugged it into my computer, nothing was detected.

My OS is Windows 10.

Are you using an external debugger for programming and debugging the dongle? The dongle does not have an onboard debugger, so it is not possible to debug it unless you use an external debugger.

Yes, of course I am using an external debugger, and successfully debuged with other samples:

RE: How to build Openthread CLI sample

Marte Myrvold — Tue, 19 Jul 2022 08:03:51 GMT

Hi,

How did you program the application to he dongle?

[quote user=""]not any log output through RTT.[/quote]

For the dongle you must use USB as transport, which you have done by setting the correct configurations, so you will get logging through this, and not RTT. So you should connect to it using a terminal emulator instead, such as Tera Term or PuTTY.

[quote user=""]When I debugged it, an error came out like this:[/quote]

Are you using an external debugger for programming and debugging the dongle? The dongle does not have an onboard debugger, so it is not possible to debug it unless you use an external debugger.

Best regards,

Marte