How to configure radio and send data over bluetooth

RE: How to configure radio and send data over bluetooth

Stian Røed Hafskjold — Mon, 07 Sep 2015 12:42:59 GMT

You can follow the same tutorial for pca10005 with nRF51822. nRF51822 is basically the same as nrF51422 just without ANT support.

Look at the compatibility matrix here, www.nordicsemi.com/.../41917, and find out which chip revision you have, and which SDK and SoftDevice you should use. (This is also described in the tutorial)

Also scroll down to "Preparing the project for a different board", to see how to configure it for the pca10005 (Which is actually a module for the nRF6310 motherboard, so you should choose nRF6310 as the board)

RE: How to configure radio and send data over bluetooth

mukesh — Mon, 07 Sep 2015 06:35:38 GMT

Thank you for the fast reply. I tried the example you mentioned. But I have some confusions. I am using nRF51822 ic and pca10005 board. So which sdk AND SOFTDEVICE I should use. I downloaded the files as per the tutorial , but it was for some other boards and ICs.Is there any ble_uart example available for my device that I mentioned above.

RE: How to configure radio and send data over bluetooth

Stian Røed Hafskjold — Fri, 04 Sep 2015 12:49:56 GMT

You should check out the posts in the tutorial section here on devzone. This tutorial will get you started: devzone.nordicsemi.com/.../