Blinking led custom board

RE: Blinking led custom board

lara — Mon, 10 Feb 2025 10:54:48 GMT

hi junior,

i also facing the same issue.have u find the solution for this?

we have also designed the custom board led with same design.

RE: Blinking led custom board

Priyanka — Tue, 30 Aug 2022 13:33:48 GMT

Okay, so I guess you are using the nRF5 SDK in the SES. Your code and connections are fine. But you could also take a look at our reference. This is how we have the connections in the DKs

I would suggest you to take a look at the following guides first, as a beginner:

Introduction to nRF5 SDK

Developing for nRF5 SDK

-Priyanka

RE: Blinking led custom board

Juniorprogrammer — Tue, 30 Aug 2022 12:53:06 GMT

Hi Priyanka,

No I’m using ses and program with the programmer on the nrf52dk using swdio and swdclk.

RE: Blinking led custom board

Priyanka — Tue, 30 Aug 2022 12:51:00 GMT

Hi Ahmet,

And you are using the nRF Connect SDK for the same?

-Priyanka

RE: Blinking led custom board

Juniorprogrammer — Tue, 30 Aug 2022 11:51:10 GMT

Hi,

No I want to test my board by using blinky, but I connected the led on my custom board on p0.13. How can I blink the led? Is it possible?

RE: Blinking led custom board

Priyanka — Tue, 30 Aug 2022 08:49:45 GMT

Hi Ahmet,

I did not understand correctly. You are using a custom board based on nRF52811 and are you using the nRF52dk just to confirm the connections and programming before that? If so, then I would recommend you to use the nRF52840DK.

The nRF52DK is used for developing for ICs nRF52832, nRF52810, or nRF52805.

Best Regards,

Priyanka