Connection disconnects with connection interval above about 200mS

RE: Connection disconnects with connection interval above about 200mS

Dawei — Tue, 13 Sep 2022 12:11:17 GMT

Thanks for your advice. We were focused on the wrong clock. Will let you know what we find. I need to ask the firmware guy about the clock configuration, I have no idea.

RE: Connection disconnects with connection interval above about 200mS

Einar Thorsrud — Tue, 13 Sep 2022 09:21:33 GMT

It could theoretically also be related to the high frequency clock. If that is inaccurate, then radio frequencies would be off etc. Before measuring it makes sense to check the crystal circuitry there as well. And you can set up a carrier using the radio test example and measure the frequency deviation to check if it is good.

A much more common issue when talking about clock accuracy and disconnects is the low frequency (LF) clock. This is because in Bluetooth, the peers sleep between connection events, and wakes up to communicate at specific times. This is based on the LF clock, and if the LF clock is too inaccurate / there is too much drift between the peers, they will try to communicate at different times. This is also why the sleep clock accuracy is exchanged between the peers so that they can account for the inaccuracy (and this is also why I asked for your firmware clock configuration, to check that the configured clock accuracy matches the actual accuracy).

RE: Connection disconnects with connection interval above about 200mS

Dawei — Tue, 13 Sep 2022 09:02:05 GMT

We also believe this is related to the circuit. Now checking all components, such as crystals. I don't think its software related. You said LF, low frequency? I thought this would be related to the HF crystal.

RE: Connection disconnects with connection interval above about 200mS

Einar Thorsrud — Tue, 13 Sep 2022 07:17:40 GMT

Hi,

If this happens under good RF conditions (not much noise / interference), then I agree that LF clock accuracy is the first thing that should be considered. Which clock source do yo use, internal RC or external 32.768 kHz crystal? How have you configured the clock in your firmware (clock accuracy etc)? Also, if you use a xtal, which exact xtal are you using (with which CL value), and which what is the value of your load caps?