Zigbee: How to send Route Record?

RE: Zigbee: How to send Route Record?

Jørgen Holmefjord — Thu, 29 Sep 2022 15:32:38 GMT

Hi,

Many-To-One Route Request (MTORR) was added in ZBOSS v3.3.0, integrated in nRF5 SDK for Thread and Zigbee v4.x.0.

The older nRF5 SDK v3.2.0 that you use integrates ZBOSS v3.1.0, which does not support this feature.

You will not be able to certify a device build with nRF5 SDK for Thread and Zigbee v3.2.0, as the Zigbee stack (ZBOSS) in this SDK version is based on Zigbee R21 specifications. You will have to migrate your project to SDK v4.2.0, which supports R22 specifications, in order to go through product certification with CSA.

I have asked our Zigbee team if it is possible to configure a Route Report packet from the application, but I have not found any APIs that suggests this is possible. I will get back to you if the Zigbee team have some APIs for this that I have missed.

Best regards,
Jørgen

RE: Zigbee: How to send Route Record?

PiotrN — Thu, 29 Sep 2022 09:58:27 GMT

Hello Jørgen,

I have read the whole thread and many others before I asked my previous question but I’m still not able to find information, why route request command is dropped in case of so simple network made of the coordinator and a router?

By the way, to keep the question more general and useful for other forum guests I’m referring to the Light Bulb example but in reality I have a ready product waiting for a green light for production.

Please find attached sniffer logs of the Light Bulb example where no reply to many-to-one route request with no reply can be seen (at the end of the file):

devzone.nordicsemi.com/.../light_5F00_bulb_5F00_joining_5F00_220929.pcapng

Additionally please find printed logs of the successful joining:

As mentioned before, there is only the coordinator and the Light Bulb example in my network. I have analyzed the ZigBee Specification (especially 3.6.3.5.2 Upon Receipt of a Route Request Command Frame) and in my opinion, when there is only the coordinator and one router in the network, the many-to-one route request can be discarded if:

there is no routing capacity
nwkSymLink is TRUE and there is no entry corresponding to the transmit device in neighbor table, or outgoing cost field of the entry has value 0

I doubt that there is no routing capacity in case of the Light Bulb example and the outgoing cost is 1. I'm not able to check the nwkSymLink value.

I can't find the reason why the route requests are not replied?

Best regards,

Piotr

RE: Zigbee: How to send Route Record?

Jørgen Holmefjord — Tue, 27 Sep 2022 15:29:23 GMT

Hi,

Please have a look at this post.

Best regards,
Jørgen