https://devzone.nordicsemi.com/f/nordic-q-a/9522/reading-datapipe-0-reset-addressHi all, I&#39;ve just started working with the nRF24L01+, and I&#39;ve come across some issues when attempting to do an initial read from the datapipe 0 RX address. After reset, setting up SPI, etc, I try to do a test clock in of register 0x0A (RX_ADDR_P0en-USTelligent Community 13Fri, 02 Oct 2015 08:22:46 GMThttps://devzone.nordicsemi.com/thread/35174?ContentTypeID=1Fri, 02 Oct 2015 08:22:46 GMT137ad170-7792-4731-bb38-c0d22fbe4515:7e1b44b1-3f42-4655-92c9-1acab4bd2364H&#229;kon Alseth<p>Hi,</p> <p>Given the reset value of &#39;0x02&#39; that you&#39;re reading out, it indicates that you&#39;re reading reguster RF_CH (0x05) instead of register 0x0a.</p> <p>If this is correct, it indicates that you&#39;re using the wrong SPI mode: <a href="https://en.wikipedia.org/wiki/Serial_Peripheral_Interface_Bus#/media/File:SPI_timing_diagram2.svg">en.wikipedia.org/.../Serial_Peripheral_Interface_Bus</a></p> <p>Could you try setting your host controller SPI mode into mode &#39;1&#39;, as according to this page? <a href="https://en.wikipedia.org/wiki/Serial_Peripheral_Interface_Bus">en.wikipedia.org/.../Serial_Peripheral_Interface_Bus</a></p> <p>Cheers, Håkon</p><div style="clear:both;"></div>