I have created customized services, but not able to connect peripheral using Android Phone

RE: I have created customized services, but not able to connect peripheral using Android Phone

SHubham — Tue, 13 Oct 2015 10:27:35 GMT

Ok I am creating a case on Nordic MyPage but how to share with you there?? Or you will get it automatically?

RE: I have created customized services, but not able to connect peripheral using Android Phone

SHubham — Tue, 13 Oct 2015 10:22:27 GMT

I used nRF Master control on Android Device to connect with peripheral device.

On the screen of nRF Master Control Panel, I got following messages

Connected to Device FFxxxxxxxxx..... gatt.discoverServices() [callback] connection state changed with status: 133 and New state : 0 (DISCONNECTED) Error (0x85): GATT ERROR

I hope you may got this.

And at the time of connecting with phone using this nRF Master control panel APP.. On my nRF51-DK board all four LED start glowing at the same time. This glowing of all four LED at the same time signify the peripheral entered into some deadlock condition (hanged).

RE: I have created customized services, but not able to connect peripheral using Android Phone

Petter Myhre — Tue, 13 Oct 2015 10:08:12 GMT

I don't understand.

RE: I have created customized services, but not able to connect peripheral using Android Phone

SHubham — Tue, 13 Oct 2015 09:10:28 GMT

If I configured My android APP properly than only I can be able to connect my device? As without APP I can not be able to connect my peripheral with phone.

RE: I have created customized services, but not able to connect peripheral using Android Phone

Petter Myhre — Tue, 13 Oct 2015 08:44:03 GMT

Could you upload your complete project so I can have a look? If it is secret you can create a private ticket in MyPage at nordicsemi.com

RE: I have created customized services, but not able to connect peripheral using Android Phone

SHubham — Tue, 13 Oct 2015 04:45:46 GMT

Thanking you for your reply. I had tested with nRF Master Control Panel. It started discovering the device.

These I got on trying to connect with peripheral using nRF Master control Panel on Android Phone:::

Connected to Device MAC HEX value.
gatt.discoverServices()
[callback] connection state changed with status: 133 and New state : 0 (DISCONNECTED)
Error (0x85): GATT ERROR

The above messages shown by nRF Master control. Along with this also the Peripheral board got hanged and all four LED of nRF51-DK board start glowing (Stable).

RE: I have created customized services, but not able to connect peripheral using Android Phone

Petter Myhre — Mon, 12 Oct 2015 12:10:35 GMT

You should test with Master Control Panel for PC or nRF Master Control Panel for Android.