power profiler application not recognizing ppk2

RE: power profiler application not recognizing ppk2

Karl Ylvisaker — Fri, 24 Feb 2023 09:01:52 GMT

Hello XYU,

I am glad to read that the tools were installed successfully, but the UI looks more broken now compared to before. Was the only change you did to install the command line tools?
Could you reinstall the power profiler application, or the nRF Connect SDK application for desktop, and see if this helps?

Best regards,
Karl

RE: power profiler application not recognizing ppk2

XYU — Thu, 23 Feb 2023 22:23:30 GMT

Hi Karl,

Thank you for recommendation. I installed those tools and I don't see those warning now. But I still cannot start ampare mode for testing yet.

Best regards,

XYU

RE: power profiler application not recognizing ppk2

Karl Ylvisaker — Thu, 23 Feb 2023 11:26:00 GMT

Hello,

The logs indicate that you are missing Jlink and nrfjprog, please install the command line tools and see if this resolves your issue.

Best regards,
Karl

RE: power profiler application not recognizing ppk2

XYU — Wed, 22 Feb 2023 15:12:54 GMT

Hi Karl,

The data logger interface does not show the mode for measurement. So I can not start testing any current.

RE: power profiler application not recognizing ppk2

Karl Ylvisaker — Mon, 20 Feb 2023 12:38:57 GMT

Hello XYU,

It seems to me that you are in the 'about' pane, instead of the Data-logger / Real-time pane (top middle). Are these the interfaces you are missing?

Best regards,
Karl