HI,
I am using the nrf_desktop sample in NCS V3.0.2, I want to buil with prj_release_dongle.conf , the setting
but build fail, I check the file Path: it should be F...
Hi:
I'm doing exercise 1 of lesson 1 of the nRF Connect SDK Intermediate course. It says: Get the source code of this course as a third-party repository within the SDK itself...
I am using the NRF Connect SDK package provided by Qorvo, and adding BLE functions to their package. I am now trying to debug my added code.
I am using Ozone as the debugger...
Hello, We are currently working on the 18031 RED cybersecurity documentation and we have to document all known exploitable vulnerabilities in the hardware and software we...
I want to verify the 4Mbps transmission mode of the nRF54L15 series through ESB samples.But the highest value measured so far is 2.34Mbps, which is much lower than 4Mbps....
Hi, nordic team
There is an issuse happened in my custom board with nrf52833,programming in ncs v2.9.0.
peripheral side is programmed base on peripheral_hid_keyboard and...
Hi all,
We are currently developing a modem application for use with a Linux host, based on a nRF9161 using nRF SDK 3.0.0 and toolcahin 3.0.1
When compiling the Serial...
I download uart sample from Nordic developer zone . at devzone.nordicsemi.com/.../is-there-a-serial-port-profile-for-ble
Because you had build the uart profile and iOS...
Hi,
I just started with the nrf 51822 eval kit. I've used keil before and am using the evaluation version. The Blinky example compiles, uploads and can debug fine (step...
Hi everyone:
by default , when a port(Port0) setting to output mode.
when i want to read the port(Port0) ,
i will get the port Output state. but at the nRF51822(NRf6310...
I have the nrf51822 eval board and I am just trying to download the blinky project. I have followed the quick start instructions in the nrf51822 user guide but every time...
Hi
In Desktop 2 v1.0.4, did you consider the debounce as keyboard buttons were pressed or released?
How long is the debounce confirming time? Thanks.
Jeffery
Hi, my name is nils. I am trying to develop on the nrf51822 eval board. I use eclipse an gcc with the j-link under windows 7 to programm/compile/and flash. I got it to work...
Hello,
We are working in the field of Electric Bike Propulsion Systems.
We want our motor to be able to communicate to I-phone/Android phone on Bluetooth.
We are searching...
Hello Nordic experts,
I can find current consumption in standby mode data from nRF24L01plus datasheet.
But it seems standby mode current consumption is not mentioned in...
We would like to be able to communicate with an nRF51422 target system from a Windows host. (for target signal processing algorithm debugging ).
Our previous system used...
how can I program SPI to select more than only one slave device with any GPIO ?
SPI Routine "spi_master_int" can select SPI0 or SPI1 only with one dedicated GPIO as Slave...
I want to know the EXT interrupt (GPINT1 & GPINT0) can use at the same time. When I use the GPINT1 & GPINT0 at the same time,only one is OK the other is faile.
