Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hi,
I'm wondering if it's possible to set hopIncrement (Core4.2 Vol6 PartB 4.5.8.2) to a specific value (not random), like 5, in current SoftDeivce. Also, if that's possible...
I've been playing around with the SDK these past few days using both Keil and ARM GCC options.
When people develop a product using this SDK, do they just clone one of the...
Looking at
\NORDIC\SDK\examples\peripheral\spi\pca10040\blank\config\sdk_config.h
These lines repeat over and over. Was there a reason for this? The first time the infdef...
I just nRFConnect to find the JLink on a Mac. JLink is connect to the devkit, a BLE400. As soon as I select the com port, nRF Connect asks me if i want to install the latest...
I was wondering what material was used for the Thingy52. I'm guessing the top was some type of cast silicone while the bottom is some type of PC. Part numbers of the exact...
Hi, I just want to know,
Is it possible to develop a device that advertise normally and be connected by mobile, but the device must always send the eddystone-format advertising...
Hi,
I wonder what transfer speed can be expected on a BLE DFU update on a nRF52832 based device in the following condition?
-SDK14.0 Secure DFU, nRF52832, Android tablet...
I get an app error SOFTDEVICE: INVALID MEMORY ACCES if I try to write/clear RESETREAS after the softdevice has been enabled.
Why is this happening?
You can reproduce...
Hi
I'm using a nRF52832 togehter with the SoftDevice SD132 and the SDK V12.2.0. I encounter the problem, that the SoftDevice runs into the softdevice_fault_handler(). The...
Hi,
I'm using the ble_app_multilink_central example in the newist SDK nRF5_SDK_12.1.0_0d23e2a, nRF52832. Now it can printf the log information. I want to use the uart to...
Hi,
How to interface UART between NRF51822QFAC and LPC1769, which tool can used for NRF51822QFAC and how to compile the source code, please send me download path for tools...
I'm observing frequent Bluetooth disconnection on my custom board which has nRF51822 SoC.
So far, I haven't been able to figure out the root cause. In order to narrow down...
Hi there,
I am currently runnning tests with the nrf52840 for university project on Bluetooth 5 and I'm struggling to figure otu how to change the PHY used,
e.g. in...
Hello together,
i know, there are similar questions about "Reading Characteristic Value", but i don't get a solution for me. My Problem:
I use nRF51DK with SD130 and the...
