Hi all,
I'm deploying an nRF9160-based device in India and hitting the familiar "which SIM actually works here" wall. Looking for current (2026) experiences, since older...
Hi all,
I've built a custom nRF9151 board, which is successfully responding to the basic factory AT commands. It won't accept a CFUN=1 command though, presumably because...
Hello!
I think there is a problem in NCS v3.3.0. nRF54L target, sysbuild build with MCUboot and TF-M, partition layout coming from devicetree (SB_CONFIG_PARTITION_MANAGER...
Hi, I'm developing a keyboard-pcb with NRF52840. I'm doing this as a hobby and are not that experienced with integrated circuits. Anyway, I designed and produced a pcb, but...
Hello,
in cases where the LTE signal strength is extremely low, we observed that the LwM2M /4/0/2 RSRP rolls over from -128 to 127. We found that the nRF Connect SDK uses...
As part of the Bluetooth LE course we need to setup and install the nRF BLE sniffer for wireshark. I have followed the explained steps in the course to set up wireshark to...
The at command documentation says that ENVEVAL is only available in system mode 2 (CFUN=2). Is there a reason why the command can't be run in any other mode? For example if...
Hello, I am working on NRF52 DK,SDK12.1.0.
When I am trying to make board into sleep mode with sleep_mode_enter(I have get sd_power_system_off),I found that RAM/UART is still...
Hi,
We designed the circuit followed the reference circuit(QFN48), and all the value of power capacities are also followed the reference circuit. But we failed in the 8kv...
Hi, I'd like to use nrf51 dongle to scan for ant/ant+ communication, but I can't understand how to do that... it doesn't work with antware sw and I don't know how to use it...
Hi,
I use NRF51822 to design a ble product,my client require that when in the front of the ble device the app can connect the ble device,and can't connect in the back of...
My Issue,
I need to be able to set radio RCV/TX signals to a specific distance. I would like to control this
through the firmware. Do you have any recommendations or examples...
Hello,
I am using Keil Lite edition and I'm receiving a linker error from exceeding the code limits in Keil. My code is 37336 bytes and apparently cannot exceed 32000 bytes...
Hi,
I'm currently working on a BLE device which works his whole lifetime on one battery. This means we have to save as much energy as possible. This is why we set our advertisement...
Hi all,
Our company is in the process of certifying a device. This device is using a nrf52832 with radio.
We had no problem to comply with the ETSI standard, but things...
I am trying to set up a custom Advertisement in nRF-Connect for Windows, using an nRF52 DK (PCA10040)
In Advertising Setup, I remove the existing "Complete local lame"...
Hi
I am looking for some example code that shows best how to talk to a servo.. If there isn't any, any ideas which example project comes the closest ?
Thanks
J
Hi,
I was reading datasheet of nRF52832, but i didn't see USB topic in that.
But i checked the SDK which has USB example for HID_keyboard and mouse?
Is that Means we are...
I am trying to run the ble-characteristics tutorial code on a custom nRF52832 board ( MetaMotionR ). The blinky example worked just fine after creating a custom_board.h file...
