Hi all,
I'm deploying an nRF9160-based device in India and hitting the familiar "which SIM actually works here" wall. Looking for current (2026) experiences, since older...
Hi all,
I've built a custom nRF9151 board, which is successfully responding to the basic factory AT commands. It won't accept a CFUN=1 command though, presumably because...
Hello!
I think there is a problem in NCS v3.3.0. nRF54L target, sysbuild build with MCUboot and TF-M, partition layout coming from devicetree (SB_CONFIG_PARTITION_MANAGER...
Hi, I'm developing a keyboard-pcb with NRF52840. I'm doing this as a hobby and are not that experienced with integrated circuits. Anyway, I designed and produced a pcb, but...
Hello,
in cases where the LTE signal strength is extremely low, we observed that the LwM2M /4/0/2 RSRP rolls over from -128 to 127. We found that the nRF Connect SDK uses...
As part of the Bluetooth LE course we need to setup and install the nRF BLE sniffer for wireshark. I have followed the explained steps in the course to set up wireshark to...
The at command documentation says that ENVEVAL is only available in system mode 2 (CFUN=2). Is there a reason why the command can't be run in any other mode? For example if...
Hi, I have a need to connect to a peripheral device from and nRF52 with a Bonded connection.
My device handles bonding when it is a peripheral, but what is needed to enable...
I'm thinking about doing some power consumption experiments with the new BLE5.0 standard.
Has anyone tried to use this power profiler kit (order# nRF6707) on the new Bluetooth5...
Hi,
we were testing Experimental BLE Multiperipheral Application, and it works on Android, but only 2 iOS devices can discover services and characteristics (4 can connect...
Hi:
I am trying to update the HEX file of gateway example using DFU bootloader(serial),i found that nrf51822 don't run to bootloader after reset, but i flash SD and BL using...
Hi,
Because we heavily depend on timeslots we cannot do the main work before the parameters are honored. But we were experiencing some issue's with the standard implementation...
I am using a PCA10040 board and the UART example from
another question .
Now, having tried some different phones I suspect that my Sony E6553 with Android 7.0 has a bug...
My BLE peripheral is an advertising entity using BLE Privacy.
The advertising address(RPA) is changing every in 15 minutes.
But, when a connection is stopped and it resumes...
But when am connected with my phone , it shows like as below
service started
connecting..
gatt=
device.connectGatt(autoconnect=false)
Activity bound to the service...
Hi,
I use ble_app_hrs_s132 project for experiment on bonding function. The version of SDK is v12.2.0. It seems that this example has all the conditions the bonding function...
Because I need to receive the serial interface in the event handler of the serial data communication protocol (custom) send out via bluetooth, a set of protocols to 25 bytes...
hi:
the nrfutil link: github.com/.../mesh_dfu
I've been having a little bit of an issue running the command "python setup.py py2exe" in cmd.exe
the error as follow:...
I'm using the nRF52 + SDK11.0.0 + s132. I have a single physical button on my hardware that can be used to toggle power to the system (though a PMIC). This same button routes...
