Hi,
I use UART bootloader SDK example(dfu_dual_bank_hci) to do update firmware on EK PCA10001 board,it can work ok.But i changed the HCI_SLIP_UART_RX_PIN_NUMBER and HCI_SLIP_UART_TX_PIN_NUMBER...
Hi. I have been trying get a notification through ANCS.
I have created an app which is made by modifying ble_app_ancs sample.
It works basically but there is one problem...
Hello,
I'm using the nrf51422 with 210 softdevice.
I'm trying to figure out a way for the receiving slave device to go to sleep when away from the master, but to wake...
To be able to upgrade FW through UART, a bootloader for nrf51822 is required in my project. I have tried out the example bootloader in SDK. But this example is using softdevice...
I followed the forum posts and nan-29 to get eclipse 4.3.2 to successfully connect to JLinkGDBServer via a Segger J-Link EDU on Ubuntu Linux.
I can start the GDB server...
I'm using Softedevice 6.0.0 and SDK 5.2. and Keil 4.7.
I Modified bootloader project so it compiles with both ble and hci transports. Currently I use button_0 and button_1...
I am working on the proj that needed 2 MCU and nrf51822 work as slave.
I would like to know any ref on how to firmware upgrade on board without external tool?
Hi we are trying to test the serial boot loader example from sdk 11,sdk 12.03 non of them working while running using nrf go studio it says enter in dfu mode and while we...
Hi, I want to use the p0.18 as a GPIO without being connected to nRESET function. So I removed "CONFIG_GPIO_AS_PINRESET" from the define option in Keil. And then i found that...
Hi there,
due to unknown reasons, my nrf52840-DK (1.0.0) didn't come back up after flashing software to it. Means the LED that usually turns on when you power it up remains...
Hello All,
I am having issues compiling the "light_switch_client_nrf52840_xxAA_s140_6.1.0" and "light_switch_server_nrf52840_xxAA_s140_6.1.0" example found in the Mesh...
Hi All,
I'm new to nRF52.
I'm working on nRF52 PCA10040 board. How want to how the secure bootloader works?
I tried to load application from DFU serial bootloader and...
I'm trying to use the sample application "\ ble_central \ ble_app_rscs_c".
If I change the NRF_SDH_BLE_CENTRAL_LINK_COUNT file from 1 to 2 in the sdk_config.h file, the...
Hi,
I am new to openthread development. My goal is to distribute measured values received from the SPI Bus over a thread network. I am using a nRF52840-DK Board, SDK for...
Hi, I have recently purchased flasher portable plus to use this device in prodcution to flash devices consisting of nrf51822_xxAA. Here are my following questions
I could...
Hi all,
I am new to BLE development. Currently developing a new BLE device using ISP1507, which is based on NRF52832. The device (server) will be communicating with a Windows...
I'm testing the throughput of nrf52 Devices . So i create custom services in nrf52Dk and send 100packet at a time and connection interval 7.5ms . I connected motog5s+( ble...
Hello,
We are facing some problem in getting output in NRF52840-QIAA-R. In our project we used pins of port-0 as SPI interface as bellow:
P0.05/AIN3 pin as CS
P0.06...
