When I initialize the SoftDevice with SOFTDEVICE_HANDLER_INIT(NRF_CLOCK_LFCLKSRC_XTAL_20_PPM, false); // Sets up Crystal Source to 20ppm 32.7628kHz
The project I based...
I am trying to make a product with NRF8002B. I finally have the product prototyped. The user will connect to the device, beep, light up, and track. It will always stay on...
Please,
It seems that "Flow Control" signal is not available on nRF24AP2-USB.
EVENT_TRANSFER_TX_START event message appears only one time after the first data packets...
I am looking for cheapest (up to few hundred USD) and simplest Arduino basic solution to track real-time RFID tags distance (also direction if possible) without additional...
Hi all,
I am new to Nordic semiconductor but I could be interessed by nRF9E5. To check if it could fit my requierement, I would like to know if it possible to configure...
Hi,
I am using ADC without external reference and no analog input in order to measure the battery level with a timer (code at the end).
I am also reading several ports...
Hi,
I'm programming the nRF51822 and save some user data into the FLASH by using pstorage_update . It works fine if I set system off mode, and wake it up. I can read back...
I want to know the project which code was developed with IAR,the project can port to keil MDK? If I could,where do I need to change,and how to do it .thanks
I use SDK15...
Hello, I have recently updated our CLI backend to use LIBUARTE and it seems to be much more reliable. I have a few assumptions I would like to clarify and a few questions...
I am about to start new quite complex project with nRF52 and I thought that maybe it is high time to use freeRTOS port from SDK. As the device is going to be powered with...
We are experiencing some mysterious but very rare events of MCU going into system OFF mode. We are using nRF51822 and S110 v7.3.0. The wake ups are most likely caused by a...
Hi,
We are using nrf51822 QFAAH00 with SDK 110 v10.0.0 with softdevice 8.0.0 in our project, In Application we are using gpio,timer,uart interrupt handler, In main function...
Hi support team,
I'm using nrf52840 with softdevice 6.1.0 and sdk 15.0. I started from the ble_connectivity example as my central and used pc-ble-driver on my host PC as...
Hi,
I´m looking for a Bluetooth low energy proximity sensor with this (or similar) characterisics:
One main (receiver) module and many secondary (transmitter)...
I'm using a custom board based on the Thingy52 board and firmware that uses the BMD-350 module containing the nRF52832.. I'd like to use the internal RC oscillator for the...
Hi,
I just found out that the scanning procedure does not time out in SDK 15. This is because in SDK 15 we are forced to restart the scanning procedure everytime an advertisement...
I am using nRF5 SDK for Thread and Zigbee 2.0.0
I am having trouble commissioning using NFC, either with the nfc_meshcop example or my own code (based on the nfc_meshcop...
Hi we are trying to test the serial boot loader example from sdk 11,sdk 12.03 non of them working while running using nrf go studio it says enter in dfu mode and while we...
