• Modulation by radio_test_example

    I use radio test example in SDK 12.2.0. Is it possible to perform modulation with PRBS9?

  • DTM or Radio Test

    Hello! I need to perform some radio tests on a board that contains an nRF52 SoC. The nRF5 SDK provides two ways of performing such tests, either using DTM, as specified by Bluetooth SIG, or using the Radio Test example. I'm aware that DTM sends packet…

  • radio test example and button handle

    Hello, I want to change mode from radio test example from button input. How can I use the gpiote for mode change from button input. I only want to use modulated and unmodulated certain fixed channel. Thank you.

  • Radio Test Example Channel Selection Issue : FCC Certification

    Hi all, I have been trying to get my Nordic nRF51822 transmit continuously on a particular channel for FCC certification. The Test lab wants me to test the product in 2402MHz, 2442MHz , 2480MHz. They want me to transmit in these frequencies separately…

  • Is it possible that nRF905 transmits well but does not receive well?

    Hi. We are developing a test equipment for devices that use nRF905. The devices use single ended connection for 50 Ohms antenna and layout recommended by datasheet (nRF905 datasheet, revision 1.5, figure 14). We achieve the measurement of RF transmitted…

  • Spectrum measurements with DTM firmware

    Hi all, we are performing some transmitter spectrum measurements using your nRFGo (PCA10005) board and an Aaronia HF-60105 spectrum analyzer. The SMA connector of nRFGo has been connected to the spectrum analyzer through a 30 dB attenuator. On the…

  • Radio test channel selection

    According to the data sheet for the nRF51822 the channel range is from 2.400 - 2.483 GHz. In the radio test example however, it limits the range of test channels to 2.400 - 2.480 GHz. Is there a reason that the top 3 channels are not accessible…
Terms of service