Hello, We are currently working on the 18031 RED cybersecurity documentation and we have to document all known exploitable vulnerabilities in the hardware and software we...
I want to verify the 4Mbps transmission mode of the nRF54L15 series through ESB samples.But the highest value measured so far is 2.34Mbps, which is much lower than 4Mbps....
Hi, nordic team
There is an issuse happened in my custom board with nrf52833,programming in ncs v2.9.0.
peripheral side is programmed base on peripheral_hid_keyboard and...
Hi all,
We are currently developing a modem application for use with a Linux host, based on a nRF9161 using nRF SDK 3.0.0 and toolcahin 3.0.1
When compiling the Serial...
Hi,
I'm using nRF SDK 16 for my application on the nRF52840 custome board. When I set both parameters (i.e., support for coded PHY and 1M PHY ) in the scan initialization...
Hi all,
I'm working on a Nordic-based system involving multiple nRF52-series chips exchanging high-rate sensor data over both radio and SPI links. The setup involves two...
Howdy!
I am attempting to develop a system using an nRF52840 and an ADS131M04EVM (ADC). Our application requires us to collect data at a high sampling rate (>= 16k SPS...
Now I am doing the BP by using the "ble_app_bps" project. I find it still advertising after connecting to the master,so the power consumption is high.So I wanth to use the...
The nRF8001 provides pipes to the Characteristics on the local GATT Server and the remote GATT server. How is this different from the handles of Attributes.
The setup for the nRF8001 that is generated by the nRFgo studio can be placed in NV-RAM or the RAM of the nRF8001. Is it possible to put a new Setup in the NV-RAM or put in...
We have some profiles that has power saving modes that changes the advertisement parameters while running. We want to change the advertising parameters from the application...
The Master Control Panel uses the PCA10000 board loaded with a ME (Master Emulator?) firmware.
Is it possible to get the source code to this firmware in order to make your...
the nRFgo studio is used as a visual editior for the nRF8001 to create Bluetooth low energy Services and Characteristics and Pipes to access them. After creating the Service...
I'm trying with a nRF24L01 device, connected to an Microchip MCP2210 USB/SPI bridge.
With this Microchip device, i cannot sent a CE pulse shortest than 130uS to transmit...
Hi,
Can the nRF51822 be set up to run thr 32kHz clock in mode?
What is the lowest possible sleep current while maintaining BLE connection timing?
Thanks
Vladim
Hi all,
I would like to use LE1 to control Remote controlled car. But we have been used another vendor's chip in the car by now. Is it possible to connect between them...
Is there any equivalent to the SPP profile from Bluetooth Classic? I've always used this as a way to transmit custom data using Bluetooth, but I can't seem to find anything...
