Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
I am trying to send data from icm20948 sensor from the sensor node to the observer node using ble mesh. Due to the data from icm20948 is too large (9 uint16_t, 18bytes) for...
Hi Nordic community, I have received nRF7002DK device and trying to make it work on v2.9.0 sdk. I'm working wifi sample project,successfully building and flashing in the device...
I have installed the nRF Connect SDK, with both the toolchain and SDK set to version V2.9. I selected the nrf54l15dk board for development, but I do not have a physical nrf54l15dk...
Hello ,
I have taken reference project which use all leads and buttons of Evaluation module NRF52833.
I want to create overlay file for this project and remove few led...
Hi Nordic Team,
The OpenThread API function otCryptoAesCcm() is not working after updating to NCS v2.6.0.
Setting CONFIG_OPENTHREAD_NRF_SECURITY_CHOICE =y seems to...
Hi!
I'm using some common bootloader code for different devices. One of my devices is a bit different, with an LED library that caused me to increase the BL size in the...
hello Nordic
i am using ncs 2.8.0 with nrf52832 and mrf52840
i am decoding a cbor file with the 'zcbor_map_decode_bulk'
the 'my_implementation_decode' is just a function...
Hi,
I'm polishing up the development of my product, and I need to use the LPCOMP driver to wakeup my NRF52840 from the deepest sleep mode. There is not much information...
Hello,
I have implemented an application for the nRF52832 that uses peripheral NUS with LittleFS. The application receives sensor data via UART and stores it to a file using...
nRF5_SDK_17.1.0
PCA10059
According to the source code:
The data length is fixed,it will still copy element-size bytes to buffer even if no so much data.
For communication...
Hi! I have multiple peripherals and centrals that I want to manage connections to. From the peripherals perspective, Is there a way to filter which centrals can connect to...
Hello,
In an nRF52840, NCS2.7.0 application (based on BT NUS shell) I need to address the following case:
UART Interrupt handler monitors incoming bytes
A working...
Dear Nordic Team,
i found many old posts about MQTT-SN being implemented for other protocols. Is there any chance to get MQTT-SN for Zepyr for the nrf9160, because we want...
