hello
i am using the Nrf52dk with Visualgdb.
i try to run the example project (tcp/IP -> client).
i am using the Nrf5 IoT sdk v0.9
Project complied successfully but i...
I'm using an nRF52 (SDK11.0.0, s132) and am able to generate a hex and axf via Keil/uVision. It uploads and works just fine using a Segger J-Link. I want to try some lower...
Hi, I'm a newbie to Nordic and need to use multiple nRF24LE1s to get ADC values and transmit them to a single nRF24L01 connected to an Arduino. I need sample Keil compiler...
HI:
i hava a sender and it send a frame every 15ms ,not use any protocol,and reciver code like as follow:
while (1) {
Rf_StartRx(ReciverSC.RfBufPointer...
Hi to everyone,
i have an mb39c811-evsk-02 and over it there is a tmp102 temperature sensor and an nrf51822.
I want to read the values of the sensor over a beacon app. ...
We have developed a custom board with an external SPI flash, which I have tested and it works.
We want to use OTA over BLE, so we have added MCUboot to the project, which...
Hi all,
I am trying to decide what DK I should go for if I want to test out the BLE Direction Finding capabilities of the SoC.
I am interested in getting the nRF5340-DK...
I'm using an nRF52832 with SDK v15.3.0 configured as an SPI slave in mode 0, with a master clock speed of 1.25 Mbps. My SPI pin assignments are:
- CS -> P0.06 - MISO ->...
I built an application and tested it with DK, and it worked well. I then created a custom PCB and attempted to flash the application, but the BLE part is failing with the...
Hello,
Platform: nRF54L15, SDK 2.9, VS Code
Our application is Matter + BLE (like NUS) based door lock application. A BLE custom service (adapted from NUS) is used to...
Hello,
I am currently learning Zephyr via the Developer Academy in preparation for an upcoming project that will use an nRF9151 and a Nordic BLE module. I will need to write...
Hi!
First of all, sorry but I will not be able to provide anything to re-create the bug... I did modify the code that may have made it happen in the first place quite a...
Hi, my two nRF52840 devices are set as peripheral and central respectively. Both devices use nRF52 SDK.
I try to update the PHY in the two devices, after they are connected...
Hi,
I was playing with my development software in VS Code everything was OK apart from the Cmake error message.
Once I had to restart my computer I couldn't build my...
Hello team,
We are developing a custom board on which eSIM is used for cellular connection. We will use Serial LTE modem application to control cellular modem through...
Hi,
I am using the nRF5340 Audio DK board with the nRF5340 Audio application under NCS v2.8.0 as a Unicast client.
I observed that changing the connection interval to...
Hey everyone,
We have been struggling to get our nRF7002DK connected to any HTTPS server. We've stripped back our evaluation setup to use "google.com" with the example ...
Hello,
I wanted to verify if two devices are communicating by using a sniffer.
After running the radio_test example, I set up parameters for each transmitter and receiver...
