Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I had the same experience as fishman and I went back to give Eclipse a try. (Post: nRF Beacon does not build on Android studio) I tried to build it in Eclipse Luna with the...
Working to comply with EN 300 328 V2.2.2 by reducing Media Utilisation to <10% on my FHSS system. I've been told that over-the-air, the NRF24L01+ actually transmits 9 bits...
I'm trying to get the settings api working with multiple partitions using little FS. Some of the implementation is specific to Nordic and was hoping to get an example of how...
We have developed a custom board with an external SPI flash, which I have tested and it works.
We want to use OTA over BLE, so we have added MCUboot to the project, which...
Hi all,
I am trying to decide what DK I should go for if I want to test out the BLE Direction Finding capabilities of the SoC.
I am interested in getting the nRF5340-DK...
I'm using an nRF52832 with SDK v15.3.0 configured as an SPI slave in mode 0, with a master clock speed of 1.25 Mbps. My SPI pin assignments are:
- CS -> P0.06 - MISO ->...
I built an application and tested it with DK, and it worked well. I then created a custom PCB and attempted to flash the application, but the BLE part is failing with the...
Hello,
Platform: nRF54L15, SDK 2.9, VS Code
Our application is Matter + BLE (like NUS) based door lock application. A BLE custom service (adapted from NUS) is used to...
Hello,
I am currently learning Zephyr via the Developer Academy in preparation for an upcoming project that will use an nRF9151 and a Nordic BLE module. I will need to write...
Hi!
First of all, sorry but I will not be able to provide anything to re-create the bug... I did modify the code that may have made it happen in the first place quite a...
Hi, my two nRF52840 devices are set as peripheral and central respectively. Both devices use nRF52 SDK.
I try to update the PHY in the two devices, after they are connected...
Hi,
I was playing with my development software in VS Code everything was OK apart from the Cmake error message.
Once I had to restart my computer I couldn't build my...
Hello team,
We are developing a custom board on which eSIM is used for cellular connection. We will use Serial LTE modem application to control cellular modem through...
Hi,
I am using the nRF5340 Audio DK board with the nRF5340 Audio application under NCS v2.8.0 as a Unicast client.
I observed that changing the connection interval to...
