SPI manually select CS pin

[Robert]

Hello ! How can I configure nrf_drv_spi with me writing the CS pin to LOW and HIGH whenever I want to address a different peripheral ?

[Roger Clark]

You can define the SS pin as not connected

NRF_SPIS_PIN_NOT_CONNECTED

See

infocenter.nordicsemi.com/index.jsp

Then use GPIO in you code to assert the CS pin youself before calling the nrf_drv_spi_transfer and clear it in the completion callback etc.

[Robert]

Thank you Roger !

[djqtsg]

Can I just use GPIO function to set or clear the CS pin ONCE in the beginning since I have only one SPI slave device connected my MCU?

[Roger Clark]

Generally just enabling the CS pin all the time can cause problems

Often the protocol for peripherals involves sending 1 or 2 byes with a register address, followed by writing or reading multiple bytes

However, devices often rely on CS going low to indicate that a new transfer is about to take place and that the next data from the MCU is a command e.g. READ REGISTER

You should check the data sheet for the peripheral you are using, to make absolutely sure it allows CS to be enabled all the time

(Personally I would not do this, because if you get out of sync you will be sending or receiving garbage , to or from the peripheral

[TEJASWINI J]

Hi Robert and Roger Clark!

We can disconnect a  PIN during the SPI Bus Initialization itself right?  ( .ss_pin = NULL)

or is it necessary  to have not connected?

Please correct me if I am wrong.