This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

NRF52 DK and Beacon HW

Hi,

I want to decide about the programming interface.

I want to know that what can be used for the flashing NRF52 especially for the beacons.

  • Hi Usman,

    Firstly flashing procedure doesn't rely on type of application so beacon or anything else you will need either any JTEG/SWD programmer (e.g. SEGGER J-Link or similar solutions from NXP, STMicro, some open source HW flashing solutions...) in case you want to flash nRF52 chip in general or you need just Nordic or SEGGER tools on host (typically Windows/Linux PC or Mac) where you connect nRF5x DK over USB (because it already has SEGGER J-Link on board and that knows SWD protocol to flash nRF5x target on the board or outside).

    Cheers Jan

Related