I am in the process of porting arduino library VL53LX01 to the nrf51822 using nrf_drv_twi functions. I will use this with S130 and thinking of using blocking mode.
I initialized without giving interrupt handler and hope it will run on blocking mode.
err_code = nrf_drv_twi_init(&m_twi, &twi_Vl530x_config, NULL, NULL);
I am thinking of using
err_code = nrf_drv_twi_tx(&m_twi, address, val, 1, false);
for the below code block in Arduino library to write.
Wire.beginTransmission(address);
Wire.write(reg);
Wire.write(value);
last_status = Wire.endTransmission();
Similary
ret_code_t err_code = nrf_drv_twi_rx(&m_twi, address, &value, 1);
for read byte instead the below code segment
Wire.requestFrom(address, (uint8_t)1);
value = Wire.read();
Anyone have any idea whether its correct to do it this way?
Is there any effect on using blocking mode for s130 functions ?
Pls help