Tried Flasher Portable Stand-Alone Mode with J-Flash 6.14 as following:
- Create .jflash Project for nRF51822-QFAA
- Open Data .Hex File
- From J-Flash, select Target | Production Programming to program nRF51822-QFAA with Flasher Portable.
- From J-Flash, download the config and data file to Flasher Portable by select File | Download Config & Data File to Flasher.
- Start Flasher Portable with Stand-Alone Mode
- Press the PROG button on Flasher Portable to program the target board.
Give the following message in Flasher.LOG file:
ERROR: Timeout while programming sector, RAMCode did not respond in time
SN: 1 - Failed
Tried reset the target device, no luck. Any suggestions?
nRF51822 Programming Header shown here: nRF51822 Prog HDR.png