Sniffer not functioning.

[khosla]

ppi.zipHi, I am using radio with ppi to advertize packets as shown in the mainc file attached. Even after allocating the access address of Bluetooth on line 196 as set_address0(0x8E89BED6); and advertizing channel selected as 37 as shown in lines 150-156 , my device doesn't show up on sniffer.

I even tried to replace the dongle considering it most likely to be hardware issue. But the problem still persists. main.c Can you please guide on this.

Thanks in advance!!

[ovrebekk]

Hi

Could you please have a look at the code for the solar beacon: https://github.com/NordicSemiconductor/solar_sensor_beacon/blob/master/src/hal_radio.c

It is also an implementation of BLE advertising using RADIO registers only.

Best regards
Torbjørn

[khosla]

Hi I have seen this code. But i coudn't find anything as such. If APP_ERROR_CHECK fails I won't have noticed it unless i am in debug mode. So i tried running in debug mode to see if all is ok. two ways i did it:

1. Setting a breakpoint in the while loop and verify that it stops there
2. in debug mode, after executing for a little while, pause execution and see where it is.

On doing the second way mentioned above, it started in a paused state and then when i run it, i get a hardfault with no call stack. Whether this indicates too small main or may be stack size?

However, when i set a breakpoint in while loop in the main, i got the hard fault before the breakpoint. But when i set some point very early in the main, it was okay then. But again i set it some time later but before the while only and agian it was a hard fault.

Can you please comment on what's going wrong over here.

And if its some problem with the stack size, how do i rectify it.

You can refer to my updated main.c file attached at the top.

Thanks!!!

[ovrebekk]

Hi Khosla

Could you zip and attach the entire project?

Then I might be able to run it, and try to figure out what is happening.

Best regards

[khosla]

Sure. You can find the project attached at the top.

Thanks!!!

[ovrebekk]

Hi
What I mean is if you can zip your project folder, with all the source and project files in it. Then all the references in the project should work, so that it can find all the files.

Best regards