This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Can I maintain a timer active during off (sleep) state in nRF51822?

Hi all,

I'm using the nRF51822-EK (PCA10001) and I'm going to develop a bluetooth cadence (and speed) sensor for MTBs. I desire low power consumption and i though to put the nRF in "system off mode" during inactivity time. The nRF51822 woke up by an analog signal (sensed by LPCOMP) whenever the bicycle's wheel perform an entire revolution. So, I must measure time between two consecutive wheel's revolution. It's possible to have a timer active during the "system off mode" ?

Thank you all!!!

Related