This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Payload size settings for dynamic payload length

I am trying to use the dynamic payload length feature, but I am not sure of what settings to use for the RX_PW_P0 - RX_PW_P5 registers. According to the documentation, for these registers zero means "Pipe not used." Does that mean one must set these registers to non-zero values to enable the pipe, even when dynamic payload length is specified (by setting DPL_PX in DYNPD and EN_DPL in FEATURE)?

Or is the content of RX_PW_P0 - RX_PW_P5 registers ignored in a dynamic payload length settings, and writing zero to these registers does not, in fact, disable the pipe?

Related