This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

How to connect nrf51822 to segger flasher?

Hi!

I have bought the nrf51822 EV KIT and it came with 5 extra nrf51822 modules but them without a board. I have researched a little and I found that I need the Segger Flasher to program those modules. So my question is, what I need to connect the Segger Flasher to this modules?

Best regards

Top Replies

Nguyen Hoan Hoang over 9 years ago +1

The Eval Kit already has jlink lite on board. The usb connector belongs to the jlink lite. Just connect it to your PC and install the software downloaded from nordicsemi.com

0 Nguyen Hoan Hoang over 9 years ago

The Eval Kit already has jlink lite on board. The usb connector belongs to the jlink lite. Just connect it to your PC and install the software downloaded from nordicsemi.com
Cancel
Vote Up +1 Vote Down

Cancel
0 michel over 9 years ago in reply to Nguyen Hoan Hoang

Thanks, I have programmed already a BLE application on the evaluation board, but now I want to program a nrf51822 module without the evaluation board.
Cancel
Vote Up 0 Vote Down

Cancel
0 Nguyen Hoan Hoang over 9 years ago in reply to Nguyen Hoan Hoang

i see. They are mot modules. What came with the EK are the chips. To use it you need to design the board to use it. If you want module, it's available from this blog site embeddedsoftdev.blogspot.ca/.../ehal-nrf51.html
Cancel
Vote Up 0 Vote Down

Cancel