This post is older than 2 years and might not be relevant anymore
More Info: Consider searching for newer posts

J-Link SWD Programming for the nrf51822

I am trying to build a custom board, based loosely on the nrf51-DK (which I have been testing). I haven't ever directly programmed a chip before (always used interface MCUs). I have bought a J-link BASE.

Firstly, I can't even find a cable to connect to the 10 pin debug in connector (on the DK), which is the same connector I was hoping to use on my board.

Do I just need to connect into the chips SWDIO and SWCLK pins, plus power and then let the software do the rest?

Any link s to guides or help would be much appreciated.

Best Wishes,

George

Related