How to configure P0.9 and P0.11 outputs for signal TX and Rx.

[Filipe]

I'm trying cominicar me through Termite between the application plate (nRF51-Dk kit) and a device that supports BLE, but the connection between PC and the kit application I am doing through the TX and RX ports. But I can not get signal memo using the [extract_location] \ examples \ ble_peripheral \ ble_app_uart \ pca10028 \ s130 \ arm5_no_packs.

[Ole Bauck]

Have you enabled hardware flow control in termite? Take a look at the "Setting up a terminal" part in this tutorial.

[Filipe]

Thanks for the comment, but I've used this exemple and nothing worked. For my intension is to feed the board with external voltage and only remove and eject data via GPIO called with the numbers of UARTs P0.11 and P0.9.

[Ole Bauck]

Are you using the debug chip on the DK to communicate via UART? Do you know that the code is running (do you see if it is advertising or see any LEDs blinking, or you can go into debug mode and step through the code)?