Connection and Advertising in Beacon

[satheesh]

Hi All,

I have enabled the UART service in my beacon application.I Configured write access and write permission to characteristic UUID. I got connected to the device and after disconnecting the beacon is not coming back to advertising mode. I have been in connectable and advertising mode. After disconnecting the beacon should start advertise the manufacture data. What change should I do ??

Thanks, Satheesh

[Wojtek]

You should start advertising manually after disconnection. it is not done automatically...

[satheesh]

can you tell how? Whether I Should go to disconnected event and start advertising again.

[Jørgen Holmefjord]

You could handle this in your on_ble_evt() function. On a disconnect, you will get a BLE_GAP_EVT_DISCONNECTED event. Here you can start advertising.

[satheesh]

thanks guys .It worked!!!!