nRF8001 setup but not visible

[user123x]

Dear Colleagues,

I am much obliged for your kind assistance to me.

My Question:

I have setup my NRF8001 successfully (please find the setup file generate by the nrfgo attached).

When I ping the nrf8001, I get a standby message (which means that every thing is working properly). However, I am not able to detect any BLE device on any type of phones or other BLE devices. I am using nrf connect to locate the signal.

Is it possible that I have missed out something and the BLE signal is not started or it there a command to start it up (I guess its not "Wakeup").

Many t3.xmlhanks for your kind and competent comments in advance.

[awneil]

In Standy, as the name suggests, it's not doing anything.

You need to start Advertising for anything to be able to see it.

Have you looked at the examples in the ble-sdk-arduino ?

github.com/.../ble-sdk-arduino

[user123x]

Hello Sir,

I got connected and then I got a PipeStatusEvent and then a Timing Event and then a disconnect (0x86). I am using the standard "nRF connect" to make a connection. The disconnect event looks as follows:

01, 03, 86, 03, 13.

0x13 means as per BT Spec V4: REMOTE USER TERMINATED CONNECTION (0X13).

I have looked at the setting of the nRF app, every thing looks normal. Cant figure out why a disconnect happens. Any help is much appriciated. Thanks.

[awneil]

Again, Have you looked at the examples in the ble-sdk-arduino ?

[David Edwin]

Have you got this working ? REMOTE USER TERMINATED CONNECTION means that the app terminated the link, what is the app that you are using ? You can use the nRF Connect app in iOS and Android to test this, you should see the Services and Characteristics that you loaded in your XML file (3.xml).

.... Note: Thanks for posting a separate question, much appreciated, instead of adding to the previous thread.