Hi,
I need to capture the data packet transmitted by ble from my phone (acting as Central), I followed the Bluetooth LE sniffer example and was able to capture the data...
Greetings
I am trying to measure the current consumption of my board (does not use a Nordic SoC), and the power profiler in unison with the NrfConnect SDK app measures current...
Hello! We recently acquired a Nordic Thingy:91 for prototyping and it was working great until I came into work this morning and it was no longer showing any signs of life...
i can't open example blinky for pca1056 in Keil C 5 in sdk _17.1.0
i have installed all package about Nordic but it isn't worked.
Beside, Can i flash code to nrf52840...
Hello, I have recently designed a custom board integrated with nrf7002 and nrf52840 qfaa. However, I'm encountering an issue while trying to program the nrf7002 OTP. The RTT...
Hi,
NCS v2.6.0
nRF52 DK
central_uart send packet to peripheral_uart, then peripheral_uart send write response packet to central_uart.
How to get the write response...
I'm writing an android application, using no.nordicsemi.android:ble:2.3.1. I connect to the sensor and write 49KB data to it. Before recording, I set the desired interval...
Maybe this is something I have overlooked, but I'm interested in running the nrf5340 audio dev with a different ISO interval than 10 ms. I'm looking into using 20 ms in order...
Hi,
I need to capture the data packet transmitted by ble from my phone (acting as Central), I followed the Bluetooth LE sniffer example and was able to capture the data...
My setup is a custom board with a nrf5340 which acts as the BLE Central and SDK 2.6.99. When I use a 52833 DK as the peripheral which has the BAS service I can connect and...
Hello Nordic team,
I would like to learn more about the capabilities of the nPM1300 in terms of current and voltage measurement. Specifically, I have a few inquiries:
...
Hello,
nRF52840
ncs-v2.5.0-rc2
I am using a GPIO interrupt to trigger a callback on every edge on a particular GPIO. I am then timing the difference in time between...
Hi all,
Im working with CODED PHY (Long Range). There was no settings for primary and secondary channel so I added it like below. The previous solution worked with BLE_GAP_PHY_AUTO...
Hi,
I have developed a USB MIDI application, in which I have deployed USB Device functionality through USB C-type connector. However, when I test the USB virtual COM Port...
After creating a directory in ncs folder, with cmake and source files, i try to add build configuration in VS code, but after the process of building occurs, the build folder...
Features
nRF52840
nRF52832
System current consumption DC/DC at 3 V
0.5μA at 3V System OFF mode,
no RAM retention
1.5μA System ON mode, no RAM retention...
Hi,
I ran into a problem with nRF52840 based firmware development
I initialize the RTC with
Prescaler = 0
CC[0] = 0x19fd
I tried clock source synthesized from...
I am thinking of developing it by reusing the nRF5340 DK circuit and the nR5340_Audio sample program. I don't know where the nRF5340's switches and LED pins are assigned in...
Hello,
I am using nrf5340 Audio DK board. In that board I have flashed a sample firmware of Unicast Gateway.
This firmware is suppose to scan the advertisement and establish...
Hi,
we are developing custom hard fault handler to get its information during non-debug mode. In order to collect the information in non-debug mode we are trying to store...
We had a strange problem with a test case of ours. We use the radio in 1Mbps BLE mode and send two packets, then receive one packet.
Our test case normally works, but fails...