First time here? Check out the Tour!
Hi, I am working on the nrf51822 board and i am only the PAC20006 board version seems to be working on it. I am using sdk 11 and soft device version s130_nrf51_2.0.1 s suggested in the compatibility matrix ... (more)
Is there any example code is available which supports DFU in central mode for nRF51 devices?
Any help will be appreciated.
i need to disable RX when data was transmit and enable RX again when data transmit complete. i tried :
NRF_UART0->TASKS_STOPRX = 1; NRF_UART0->TASKS_STARTRX=1; NRF_UART0->TASKS_STOPTX=1; NRF_UART0->TASKS_STARTX=1;
( i use SDK11 pca10028) but nothing happend,i still ... (more)
I am working on an application that needs to use pairing/bonding. I am incorporating peer manager into the project. I have included in Makefile paths the following:
$(SDK_ROOT)/components/ble/peer_manager\ $(SDK_ROOT)/components/libraries/fstorage \ $(SDK_ROOT)/components/libraries ...
Hi, I am using NRF51822 and sdk12.2. I am using Softdevice s130 with peripheral experiment_ble_blinky example. I have merge UART example in this and it is working fine.
Yesterday i flashed and it was working perfectly. Even i connected ... (more)
Hi, I am using NRF51822 and GCC compiler. I am using softdevice S130. SDK 12.2. I want to receive the data from Peripheral that is one way only. I want to use multilink central application on NRF51822. When i ... (more)
Hi, I am using SDK v12.2 and gcc compiler. S132 softdevice for nrf51822 controller. And i am using s132 softdevice. I want to connect multiple nrf51 devices (approx. 14) for sharing data among themself. So, i think i will ... (more)
I am trying to interface an external ADC to NRF51-DK i am presently reading SPI ADC code values on BUTTON press event. I am able to read the values from ADC properly on button press.
I want to ... (more)
Most of the sections of my application are functioning as I want it to, except these two (step 3 and step 4).
There are similar questions posted, but none of them have able to help me out.
I am trying to add multiple base UUIDs in order to create 128-bit UUIDs for my characteristics that increment the LSB starting at a ... (more)
I am currently working on project that uses BLE peripheral and BLE central for automatic sensor calibration on custom board. There is an initial connection where both central and peripheral connect and successfully communicate data on notification characteristic from ... (more)
I am developing on NRF51822 custom board but I had a problem on how to init TWI driver to communicate with MPU6050.
In short, when receiving a BLE_CONNECTED event I trigger a TIMER wih rearming every 2second. Within the ... (more)
I debug the DFU Bootloader through UART,I am sure the APP code is complete updated,but the application does not run when the device is after bootloader to auto soft reset,but,the power on reset or pin reset ... (more)
one wire library for nrf51822 With example tnx
i am total beginner to the nrf51822. i am going through the nan-36_v1
app note is using s110 but i can't find that soft device in sdk ? is there any changes has to be done if i followed the ... (more)
I have merged all the 4 file's together (app.hex, app_valid_settings.hex, softdevice.hex and dfu.hex). Then I uploaded the custom app with dfu services enabled using nrfgo Studio. (Custom app = UART example) The board starts advertising and ... (more)