First time here? Check out the Tour!
I have been analyzing the current consumption of my nRF52832 dev kit today using both a multi meter and an oscilloscope with a resistor. I'm not sure what I exactly did that lead to this, but now my board ... (more)
I just had a quick question - currently I'm using standard drive mode for everything, however in one case I'm driving an IR transmitter that could really do with a little more current.
What are the downsides of ... (more)
Hi. I use the nRF51882 and Arduino ide for developing. My main goal is turn on and off the Led thru the Bluetooth interface. But when I use the UART service for it I have a very high current. It ... (more)
Hello, I designed a board with a nrf51822 on it. My problem now is, that this chip needs far too much current (with no firmware on it) when I apply the 3V3 power to it. I tried to use a ... (more)
I migrated my project from softdevice S110 7.1.0 on a nRF51422 FAC to softdevice S110 8.0.0 and an nRF51822 FAA G3. My code used to have a current consumption around 10 to 15 uA.
Now ... (more)
I would to know why when the DC/DC is enabled the current is very high (57mA) during RF sending.
Why at the end of RF sending the current is higher than previously (15.4mA -> 16.5mA) & 12.3mA ...