First time here? Check out the Tour!
I'm trying to enable the monitor debug mode work with iar but I have some doubts about the address used in the EnableMonMode.mac macro provided in one of the blog here.
The address is
"SetMonModeVTableAddr=0x1B000". I ... (more)
I'am realy new to nRF52 development. I want to start with a simple demo as shown on https://www.nordicsemi.com/eng/Produc....
What HW do I exactly need to buy to start playing? I have no experience with ... (more)
I am following Tutorial 7 on "Development with GCC and Eclipse" and I am working in the Windows 8.1. I have followed instructions from the tutorial for installing the arm-none-eabi toolchain and the SDK files, so I am at ... (more)
Installed SES, nRF Go, & SDK.
Imported the example. Compiles nrf52832_xxaa_s132 Internal. Launches and gets to memory check
... asked and answered many times. I understand what needs to be done, just not WHERE to do it ... (more)
I have an nRF5- DK and I'm following this tutorial. I loaded the softdevice, I can compile, I can load the flash, I can see the output in Termite, I can change the code to print different information to ... (more)
Hello every one,
So after I made my 3rd party NRF52832 board and flashed softdevice S132 with arduin ide and ST link V2 I'd like to migrate to something more serious in term of software that will allow me ... (more)
The question has been answered before, but the answer references a document called nAN-29 at this link: http://www.nordicsemi.com/eng/nordic/.... Which doesn't seem to be working. I really need to know how to start from a ... (more)
I'm using nrf52 with SDK version 12.0.0. I'm trying to use the FDS for my application. I used one of the existing fds example from link fds_example.
With this example, I call the function "fds_test_init" which ... (more)
In the last month i bought the nr52-dk, my first two steps handling it were:
I know this is somewhat "how long is a piece of string". I'm happy for guidance rather than solid numbers:
I'm trying to spec a "keep alive" circuit for an nRF51822 project. The general principle is there is ... (more)
I followed the instructions and comments in https://devzone.nordicsemi.com/tutori... . I built a project around the ble_app_gls example (with a couple of minor changes such as using -DNRF_LOG_USES_RTT=1) . The project compiles and runs just fine if I ... (more)
I would like to start a pwm signal on PIN 15 while BUTTON_1 or BUTTON_2 is pressed. If BUTTON_1 or BUTTON_2 is released, than there should be no signal(low) on PIN 15.
-SDK 8 ... (more)
What is the best place to get started with nRF51 and BLE development?
Hello- I'm trying to load the Blinky example, I am using the nRF51822 Evaluation board. I am able to compile but cannot load the board, a window with "Cannot Load Flash device Description!" comes followed by "Error:Flash download ... (more)