DTM sample for nRF52832

[brec]

Is there a DTM sample for the nrf52dk_nrf52832?

I see the sample supports nRF52840 and higher according to the docs.

I tried selecting the nRF52dk, and everything compiles and flashes without error, but I get no response on the UART, like I do with nrf52840dk_nrfrf52840 - using the Realterm instructions.

I'm using NCS v2.6.1.

Thanks,

Bob

[brec]

Looks like I had a bad board. I switched to another board and I'm getting terminal replies. Odd that the "bad" board was working fine for other applications.

Anyway, I guess I'll change the question to: Are there any issues I should be aware of when using this sample with the nRF52832?

[Vidar Berg]

Thanks for the update. I would expect the DTM sample to work with the nRF52 DK board, even though it is not listed as a supported target. The reason this board is not listed is that we do not run our tests on this particular board.

brec said:

Odd that the "bad" board was working fine for other applications.

Yes, this is a bit strange. Does the UART <-> USB communication work with other samples? If not, maybe the issue is with the Jlink serial bridge.

[brec]

Yeah, I ran many other examples on it. It is an old board that's been tossed around my office, though. Time for the recycle pile.