Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
UART Hardware Flow Control 0

Hello Nordic community, using nrf5-sdk for nrf52840 SoC, I followed the uart example as below. The uart tx and rx works fine BUT NOT THE HWFC eg. When the CTS is set...
36 views

0 replies

Started 14 hours ago
by maveli
Not Answered
What are the features, performance, and usage limitations of the built-in GNSS and 4G in the nRF9151 NTN module? 0

Hello, We are currently designing an NTN satellite IoT terminal product based on the nRF9151 NTN module, primarily for tracker-type applications. In addition to NTN satellite...
- Evaluation
- nRF9151
- NTN eval
- hardware
68 views

0 replies

Started 18 hours ago
by Baoxiang
Not Answered
Clarification on nRF21540 FEM TX Gain Selection (CONFIG_MPSL_FEM_NRF21540_TX_GAIN_DB vs MODE Pin / POUTA & POUTB) 0

Hi Nordic Team, Below are the configurations that I have done for the nRF21540 FEM. .config file # # Multiprotocol service layer (MPSL) # # CONFIG_MPSL_FEM_ONLY is not...
52 views

0 replies

Started 19 hours ago
by Uma Maheshwar Reddy
Not Answered
nPM1300 EK charge‑discharge profile logging abnormal at 45 °C 0

Excuse me. When the customer uses the nPM1300 EK for battery charge‑discharge profile logging, after charging completes at 45 °C and the USB cable is unplugged as prompted...
84 views

0 replies

Started 2 days ago
by Mason Bu
Not Answered
PWM in nRF54L15 with power management 0

Sorry, this post is deleted.
763 views

0 replies

Started 9 months ago
by Gujju

Recent in the DevZone Blog

Getting Started with the Thingy:52 and GCC/GDB

Daniel Veilleux

The Thingy:52 IoT Sensor Kit is a fancy development board that combines the nRF52832 SoC, a handful of sensors and user interface components, and a rechargeable battery. Although the Thingy is available…
- 20 Jul 2018
Provision, configure and control Bluetooth mesh networks with nRF Mesh

Petter Myhre

nRF Mesh are open source libraries for building your own Android and iOS Bluetooth mesh apps. It is also the name of the apps demonstrating a subset of the capabilities of the libraries. Use them in test…
- 25 Jun 2018
nRF52832 Buttonless DFU Development Tutorial - GitHub

gamnes

This tutorial is valid as of 2018-06-06, updates to tools and SDKs might have been made since then. Please review the information on http://infocenter.nordicsemi.com/ to see if any updates have been made…
- 12 Jun 2018
Optimizing Power on nRF52 Designs

notsane0

As customers reach the end of their design cycle, their attention generally falls on power optimization, especially for battery powered designs. The following are hints for achieving the lowest possible…
- 30 May 2018
New Smart Remote 3 SDK release enables cost optimized Bluetooth 5 voice remote controls

Pär H

It has been some time since we released new SDK for the nRFready Smart Remote 3 for nRF52 Series. The recently released rev 1.2 of the firmware introduces a lot of new features and improvements. This SDK…
- 24 May 2018
Accurate State of Charge Measurements For Li-Ion Batteries Using a State of Charge vs Open Circuit Voltage Lookup Table

Bjørn Kvaale

We have had a few questions on the Nordic DevZone related to state of charge estimation of Li-Ion batteries when used in conjucture with an nrf52 DK. This blog post will show you how to customize your…
- 14 May 2018