Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Hardware based downgrade protection with B0 and mcuboot 0

Hi, I have B0, mcuboot and then application as my partitions. We plan to support upgrade of both mcuboot and application. Based on this below Kconfig snippet, it looks...
14 views

0 replies

Started 1 hour ago
by Ramakrishnan
Not Answered
CDC ACM receive recovery for the older sdk-zephyr driver 0

Should sdk-zephyr carry this ring-buffer adaptation or adopt the newer upstream receive implementation from github.com/.../122772 At sdk-zephyr `3876d730`, RX BUSY remains...
- development
- software
- nRF Connect SDK
- zephyr
- usb
- nRF5340
24 views

0 replies

Started 3 hours ago
by David Rosen
Not Answered
SB_CONFIG_MCUBOOT_HARDWARE_DOWNGRADE_PREVENTION + SB_CONFIG_MERGED_HEX_FILES fails to configure without NSIB 0

Setup: nRF Connect SDK v3.4.0 (LTS), custom board based on nRF54LM20A, sysbuild with MCUboot as the only bootloader (no NSIB / b0), DTS partitions (SB_CONFIG_PARTITION_MANAGER...
37 views

0 replies

Started 17 hours ago
by Konstantin Klitenik
Not Answered
Two-chip design (nRF54L + nRF9151): best configuration, handle FOTA of both firmwares over NB-IoT and over BLE 0

Hi, We are designing a battery-powered product based on two Nordic chips and would like your recommendation on the overall architecture before we freeze the hardware, having...
- development
- nb-iot
- nRF9151
- bluetooth le
- hardware
- nRF54L10
58 views

0 replies

Started 20 hours ago
by ruben94m
Not Answered
nRF93M1 mfw 1.5.0: TERMINAL CAPABILITY IPAd bit for SGP.32 eUICCs 0

Hi, GSMA SGP.32 v1.3 section 3.8.2 and 3.8.4: the device selects IPAd or IPAe mode with the TERMINAL CAPABILITY command at UICC initialisation. Tag 84 , byte 1, bit 1 set...
40 views

0 replies

Started 21 hours ago
by erkkie

Recent in the DevZone Blog

Start Up Extreme Norway

John Leonard

Last week I attended what was my first Startup event, but after experiencing the energy there, I can safely say it will not be my last. 3 days of seminars, networking and lots of fun kicked off in Bergen…
- 22 Jun 2015
Step by Step Guide to Setup and Start Developing with the nRF51 DK and Keil

Pratyush Dave

The purpose of this blog is to provide a step by step guide to help a developer, starting off with the Nordic Semiconductor nRF51 DK, get the tools installed and get the software (SW) development environment…
- 17 Jun 2015
Debugging using QtCreator on Mac

wim

This post started as a question, but got the suggestion to post this as a blog post. Here it is. I have been trying to get QtCreator configured such that I can use it as my IDE for the nrf51822 on Mac…
- 12 Jun 2015
Trying OpenWRT Chaos Calmer (15.05 RC1) on Raspberry Pi 2

Jun Qing ZOU

| |.-----.-----.-----.| | | |.----.| |_ | - || _ | -__| || | | || _|| _| |_______|| __|_____|__|__||________||__| |____| |__| W I R E L E S S F R E E D…
- 11 Jun 2015
Trying OpenWRT Chaos Calmer (15.05 RC1) on Asus RT-N16

Jun Qing ZOU

| |.-----.-----.-----.| | | |.----.| |_ | - || _ | -__| || | | || _|| _| |_______|| __|_____|__|__||________||__| |____| |__| W I R E L E S S F R E E D…
- 11 Jun 2015
Compatibility between DFU bootloader and DFU master

Hung Bui

We have been receiving quite a few questions about the compatibility issue between the bootloaders from different SDK versions and the DFU master such as nRF Master Control Panel, nRFToolbox, etc. In…
- 10 Jun 2015