Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
nRF9151-DK SWD access lost after external supply, recover always fails (error -102) 0

I get the following error when flashing my nRF9151DK. I think this happened after I accidently powered NRF_VDD(3.3V) through the current measurement jumper, while the board...
3 views

0 replies

Started 21 minutes ago
by Ingmar
Not Answered
Matter ICD example (contact sensor example) not change to LIT mode with Apple home kit 0

I build contact sensor example (use nrf connect sdk v3.2.1, nrf52840 chip) and try commissioning with apple home kit (use homepod mini), device commissioning succeed but cannot...
16 views

0 replies

Started 3 hours ago
by sangphan
Not Answered
Using NCS Docker image with JLink 0

Hi devzone, I am starting to write some tests for my application, and I have a couple questions/remarks about the provided Docker image. Link to documentation . 1/ The...
15 views

0 replies

Started 14 hours ago
by NicolasGoualard
Not Answered
I am trying to install the SDK and whilst I can get to the point of installing v3.2.0 or v3.2.1 the installation fails with Failed to read toolchain environment 0

I have done a clean install of the SDK on Debian 13 I have nrfutil install and its working fine - i have tried installing both the v3.2.1 and v3.2.0 toolchains and in both...
29 views

0 replies

Started 18 hours ago
by simonp119
Not Answered
PAwR response delayed by one periodic interval 0

Hello, We are using 2 nRF5340-based devices running: samples/bluetooth/periodic_adv_rsp samples/bluetooth/periodic_sync_rsp with the PAwR configuration (modified...
24 views

0 replies

Started 1 day ago
by droid

Recent in the DevZone Blog

Step by Step Guide to Setup and Start Developing with the nRF51 DK and Keil

Pratyush Dave

The purpose of this blog is to provide a step by step guide to help a developer, starting off with the Nordic Semiconductor nRF51 DK, get the tools installed and get the software (SW) development environment…
- 17 Jun 2015
Debugging using QtCreator on Mac

wim

This post started as a question, but got the suggestion to post this as a blog post. Here it is. I have been trying to get QtCreator configured such that I can use it as my IDE for the nrf51822 on Mac…
- 12 Jun 2015
Trying OpenWRT Chaos Calmer (15.05 RC1) on Raspberry Pi 2

Jun Qing ZOU

| |.-----.-----.-----.| | | |.----.| |_ | - || _ | -__| || | | || _|| _| |_______|| __|_____|__|__||________||__| |____| |__| W I R E L E S S F R E E D…
- 11 Jun 2015
Trying OpenWRT Chaos Calmer (15.05 RC1) on Asus RT-N16

Jun Qing ZOU

| |.-----.-----.-----.| | | |.----.| |_ | - || _ | -__| || | | || _|| _| |_______|| __|_____|__|__||________||__| |____| |__| W I R E L E S S F R E E D…
- 11 Jun 2015
Compatibility between DFU bootloader and DFU master

Hung Bui

We have been receiving quite a few questions about the compatibility issue between the bootloaders from different SDK versions and the DFU master such as nRF Master Control Panel, nRFToolbox, etc. In…
- 10 Jun 2015
"OpenWRT Series" #1: setting up TP-Link WDR4300 (or N750) for Bluetooth Low Energy 6LoWPAN

PK

The first version of Nordic IoT SDK has been released over 6 months. Till now, there have been no well-known router solutions supporting Bluetooth Low Energy over IPv6. This made us the BLE application…
- 10 Jun 2015