Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
DECT MAC: security key by network 0

My DECT nr+ PT supports connecting to either of a set of networks, which of course have different integrity and cipher keys. While scanning for cluster beacons, I can receive...
16 views

0 replies

Started 2 hours ago
by chrysn
Not Answered
Incorrect explicit typecast in lwm2m_connmon.c of nRF Connect SDK 0

Hello, in cases where the LTE signal strength is extremely low, we observed that the LwM2M /4/0/2 RSRP rolls over from -128 to 127. We found that the nRF Connect SDK uses...
13 views

0 replies

Started 2 hours ago
by Christian Zingl
Not Answered
Wireshark BLE sniffer not showing the nRF interface 0

As part of the Bluetooth LE course we need to setup and install the nRF BLE sniffer for wireshark. I have followed the explained steps in the course to set up wireshark to...
16 views

0 replies

Started 3 hours ago
by David012
Not Answered
AT%ENVEVAL In PSM 0

The at command documentation says that ENVEVAL is only available in system mode 2 (CFUN=2). Is there a reason why the command can't be run in any other mode? For example if...
41 views

0 replies

Started 1 day ago
by thomasGronroos
Not Answered
TWIM I2C soft reset function? 0

Hi The TWI driver has a twi_clear_bus() function but the TWIM does not. I'm getting an I2C error, and need to do I2C soft reset. I'm doing this manually at moment but...
58 views

0 replies

Started 4 days ago
by Liam

Recent in the DevZone Blog

Motor Control over BLE with nRF51822 and TB6612FNG

Mahesh Venkitachalam

In this project, we will control two motors over BLE using the Nordic nRF51-DK. To do this, we will use a motor driver based on the Toshiba TB6612FNG chip. We will use GPIOs and PWM to communicate with…
- 5 Aug 2015
Create Hurricane Tunnel Broker on Raspberry Pi

Eugene Yu

This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4 network. The tunnel broker is providing IP conversion service with 6in4. Preparation Raspberry Pi…
- 4 Aug 2015
An appeal to makers - why you should document your project, and how you can do it

Mahesh Venkitachalam

An appeal to makers - why you should document your project, and how you can do it. http://electronut.in/why-how-document-project/
- 3 Aug 2015
ADXL 345 Tutorial

Milad

Hello all, this tutorial goes to a fellow named Emil who helped me with this project. Number 1_ Make sure you set up the terminal viewer For debugging with real.You need it to see the values coming outta…
- 1 Aug 2015
nRF51 Qt GCC Example

Jacob Portukalian

Hi Everyone! At Sky Wave Design, we recently switched all of our Nordic development over to using GCC and using Qt Creator as the IDE. We have released our example project on github for those of you…
- 31 Jul 2015
ROM and RAM Management

Øyvind Karlsen

Introduction Here are some tips and tricks to manage your application size. RAM and ROM usage The total RAM usage is: ZI-data + RW-data The total flash usage is: Code + RO-data + RW-data …
- 28 Jul 2015