Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Skylo NTN: Signal Quality Check feature 0

The NTN AT command guide documents a "Signal quality check" option for performing a pre-check before attempting to re-attach to the Skylo network: https://docs.nordicsemi...
- software
- Evaluation
- nRF9151
- NTN eval
23 views

0 replies

Started 3 hours ago
by JordanYates
Not Answered
timeout occured while handling debug power 0

Hello, I am trying to flash and debug a custom board using the Raytac MDBT42Q-512KV2 that uses the nRF52832 module mounted. I tried this using the jlink plus and the nRF52...
27 views

0 replies

Started 10 hours ago
by uodami
Not Answered
Can traces be "pulled through" unused balls? 0

I have a similar question to this , however it's for the nRF54 family. Can I route similar the SWD signals out through unused pins/balls on a BGA? In this case, I'd route...
27 views

0 replies

Started 12 hours ago
by Seth_Kazarians
Not Answered
MCUBoot + CPUAPP + FLPR with BLE DFU 0

Hi DevZone, I am currently working on a project that uses MCUboot (DFU over BLE) on the CPUAPP core together with a custom FLPR application. I successfully got this working...
36 views

0 replies

Started 12 hours ago
by Notnac60
Not Answered
Custom made board on nRF9151, GPS pin back-powering VDD_GPIO 0

Hi Nordic, We are building a custom board using the nRF9151 LACA. We see a back-powering issue between the GNSS antenna bias rail and VDD_GPIO. Setup: VDD_GPIO...
- development
- GPS
- nRF9151
- hardware
38 views

0 replies

Started 15 hours ago
by Bobo0

Recent in the DevZone Blog

Running micro-ESB concurrently with BLE

Audun

Introduction Using proprietary protocols can be an effective way of addressing shortcomings in BLE. When communicating between two nRF chips, one can for example use a different packet format or different…
- 14 Aug 2015
FruityMesh open sourced - Connection based meshing that will run on batteries

Marius Heil

Hello everybody, I have just published the sourcecode of FruityMesh on GitHub. It is a meshing algorithm that uses standard BLE connections. Plug in as many nodes as you like and they will automatically…
- 12 Aug 2015
Developing Nordic nRF51 Projects with Visual Studio

ivan

This tutorial shows how to create and debug a basic project for the Nordic nRF51-DK using Visual Studio. Before you begin, install VisualGDB 5.0 or later. Start Visual Studio and begin creating a new…
- 6 Aug 2015
Motor Control over BLE with nRF51822 and TB6612FNG

Mahesh Venkitachalam

In this project, we will control two motors over BLE using the Nordic nRF51-DK. To do this, we will use a motor driver based on the Toshiba TB6612FNG chip. We will use GPIOs and PWM to communicate with…
- 5 Aug 2015
Create Hurricane Tunnel Broker on Raspberry Pi

Eugene Yu

This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4 network. The tunnel broker is providing IP conversion service with 6in4. Preparation Raspberry Pi…
- 4 Aug 2015
An appeal to makers - why you should document your project, and how you can do it

Mahesh Venkitachalam

An appeal to makers - why you should document your project, and how you can do it. http://electronut.in/why-how-document-project/
- 3 Aug 2015