Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
nRF54LM20 FOTA BLE doesn't swap images 0

Hello I need some advice on FOTA via BLE on the nRF54LM20B. I managed to get FOTA working to upload an updated image via BLE, but after a reboot, the new image doesn't load...
4 views

0 replies

Started 19 minutes ago
by iotdeveloper
Not Answered
the min current in nrf5340 ncs sdk 0

I am using the nRF5340 development board to program the LBS example from the NCS SDK2.7. After system-off, the current is still several tens of microamps, which differs from...
29 views

0 replies

Started 8 hours ago
by pipixia_1_1
Not Answered
Unable to add HW device to Cloud Device Management 0

When trying to add the device to the Nordic Cloud Device Management interface, I get the following error. "There was an error adding your device: No device found for this...
20 views

0 replies

Started 8 hours ago
by Ade
Not Answered
nrf52dk cannot find max30101 breakout board over i2c 0

Hi, I am using the heart rate sample. I have connected ground to ground, 3.3v to vdd, SDA to pin 26 and SCL to pin 27. I have 4.7k pullup resistors on SDA and SCL. When...
20 views

0 replies

Started 10 hours ago
by hemmie
Not Answered
Struggling to isolate custom nRF52840 board from DK on-board debugger 0

Hi, I am developing a custom PCB based on the nRF52840 and am currently trying to flash/debug it using an nRF52840-DK (PCA10056) as an external debugger. connected devices...
24 views

0 replies

Started 12 hours ago
by lassey0

Recent in the DevZone Blog

Developing Nordic nRF51 Projects with Visual Studio

ivan

This tutorial shows how to create and debug a basic project for the Nordic nRF51-DK using Visual Studio. Before you begin, install VisualGDB 5.0 or later. Start Visual Studio and begin creating a new…
- 6 Aug 2015
Motor Control over BLE with nRF51822 and TB6612FNG

Mahesh Venkitachalam

In this project, we will control two motors over BLE using the Nordic nRF51-DK. To do this, we will use a motor driver based on the Toshiba TB6612FNG chip. We will use GPIOs and PWM to communicate with…
- 5 Aug 2015
Create Hurricane Tunnel Broker on Raspberry Pi

Eugene Yu

This blog introduces how to create tunnel broker service in order to support IPv6 on your IPv4 network. The tunnel broker is providing IP conversion service with 6in4. Preparation Raspberry Pi…
- 4 Aug 2015
An appeal to makers - why you should document your project, and how you can do it

Mahesh Venkitachalam

An appeal to makers - why you should document your project, and how you can do it. http://electronut.in/why-how-document-project/
- 3 Aug 2015
ADXL 345 Tutorial

Milad

Hello all, this tutorial goes to a fellow named Emil who helped me with this project. Number 1_ Make sure you set up the terminal viewer For debugging with real.You need it to see the values coming outta…
- 1 Aug 2015
nRF51 Qt GCC Example

Jacob Portukalian

Hi Everyone! At Sky Wave Design, we recently switched all of our Nordic development over to using GCC and using Qt Creator as the IDE. We have released our example project on github for those of you…
- 31 Jul 2015