Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
UniqueID attribute of the Basic Information Cluster is empty 0

Hi, In some cases, the UniqueID attribute of the Basic Information Cluster is empty (no value is set). CONFIG_CHIP_LAST_FABRIC_REMOVED_ERASE_ONLY is enabled. Environment...
2 views

0 replies

Started 4 minutes ago
by chiba
Not Answered
nrfcredstore - Failed to list credentials 0

Environment: nRF Connect SDK v3.4.0 on macOS Golden Gate 27.0 and Sequoia 15.8 Device: nRF9151-DK Problem occurred during build and testing of AWS connectivity to AWS...
28 views

0 replies

Started 5 hours ago
by zpm1066
Not Answered
nRF54L15 - Does SPI-mode SD NAND Flash work with Zephyr SDHC-SPI driver? 0

Hi Nordic Team, I am working on a custom nRF54L15 board using NCS, and I would like to use an SPI-mode SD NAND Flash (LGA8/SOP8 package, SD 2.0/SDHC compatible, SPI interface...
32 views

0 replies

Started 6 hours ago
by moke0
Not Answered
Which n Value (3, 4, or 5) Should Be Used for nRF54L15 Bluetooth Qualification Intermodulation Testing? 0

Hello Nordic team, I have a question regarding the Bluetooth LE RF-PHY Intermodulation Characteristics test (Bluetooth Core Specification Vol. 6, Part A, Section 4.4)...
45 views

0 replies

Started 7 hours ago
by muratec_icc
Not Answered
nRF54L15 sQSPI intermittently reports successful short RX transactions with all-0xFF data 0

I am developing a custom nRF54L15 board using a GigaDevice GD5F1GQ5REYIGR SPI NAND connected through the nRF54L15 sQSPI/MSPI interface. I have encountered a highly reproducible...
37 views

0 replies

Started 8 hours ago
by Tim012

Recent in the DevZone Blog

Bluetooth pairing vulnerability

PaKa

The Bluetooth SIG released an errata for the 4.2 and 5.0 versions of Bluetooth specification on July 23rd relating to a potential vulnerability with the pairing procedures. For Bluetooth low energy; this…
- 27 Jul 2018
Getting Started with the Thingy:52 and GCC/GDB

Daniel Veilleux

The Thingy:52 IoT Sensor Kit is a fancy development board that combines the nRF52832 SoC, a handful of sensors and user interface components, and a rechargeable battery. Although the Thingy is available…
- 20 Jul 2018
Provision, configure and control Bluetooth mesh networks with nRF Mesh

Petter Myhre

nRF Mesh are open source libraries for building your own Android and iOS Bluetooth mesh apps. It is also the name of the apps demonstrating a subset of the capabilities of the libraries. Use them in test…
- 25 Jun 2018
nRF52832 Buttonless DFU Development Tutorial - GitHub

gamnes

This tutorial is valid as of 2018-06-06, updates to tools and SDKs might have been made since then. Please review the information on http://infocenter.nordicsemi.com/ to see if any updates have been made…
- 12 Jun 2018
Optimizing Power on nRF52 Designs

notsane0

As customers reach the end of their design cycle, their attention generally falls on power optimization, especially for battery powered designs. The following are hints for achieving the lowest possible…
- 30 May 2018
New Smart Remote 3 SDK release enables cost optimized Bluetooth 5 voice remote controls

Pär H

It has been some time since we released new SDK for the nRFready Smart Remote 3 for nRF52 Series. The recently released rev 1.2 of the firmware introduces a lot of new features and improvements. This SDK…
- 24 May 2018