Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
Using the Softdevice Controller without RTC Crystal 0

I want to use the Softdevice Controller without a crystal on the RTC. I configured my project with Advertiements look fine, but interaction with a BLE central either throw...
57 views

0 replies

Started 21 hours ago
by Sven Haedrich
Not Answered
NRF5340-AUDIO Unicast-Server / Unicast-Client configuration 0

Hi everyone, These days I'm evaluating the Nordic nRF5340 to manage audio from two microphones to one dongle station. To achieve this, I configured two nRF5340s as unicast...
54 views

0 replies

Started 22 hours ago
by Pier Luigi
Not Answered
Planning to use 3.7V non-Rechargable battery with npm2100 with an additional diode? 0

I am planning to use 3.7V non Rechargable Battery with Diode and Reverse Protection circuit with npm2100, Would like to build a Fuel Guage model for this as this is not available...
52 views

0 replies

Started 23 hours ago
by rsramki
Not Answered
MCELL search type for lte_lc_neighbor_cell_measurement() 0

Hello, I am currently evaluating MCELL location on an existing project, based on nRF9160. After some trial and errors, I managed to get it working. However, I ma a bit...
38 views

0 replies

Started 1 day ago
by Vincent44
Not Answered
How to Set TX Power for Response Packets in periodic_sync_conn? 0

HI I am currently using the nRF54L15 chip with NCS 3.2.1, carrying out secondary development based on the periodic_sync_conn sample project. I intend to adjust the transmit...
38 views

0 replies

Started 1 day ago
by joey

Recent in the DevZone Blog

The S132 v5.1.0 is now production tested on nRF52810

Petter Myhre

This blog describes how you can setup a Segger Embedded Studio example for PCA10040E (emulating nRF52810) from nRF5 SDK 14.2 to use S132 v5.1.0, instead of S112. The procedure should be similar for the…
- 12 Sep 2018
Adding custom commands to a BLE example using Nordic UART Service

Håvard

A common thing to do is to use the Nordic UART Service for quick prototyping. Often the example itself is used as a starting point (ble_app_uart). But sometimes we use other starting points, and want to…
- 6 Sep 2018
Using Two-Factor Authentication (2FA) with the Nordic DevZone

esivertsen

Did you know you can use two-factor authentication to enhance the security of your DevZone account? In this little blog, I’ll show you how to enable Two-Factor Authentication (2FA) with your DevZone account…
- 30 Aug 2018
Introduction of SDH and SDK v15.0 software architecture

Amos Lin

The SDK software architecture has been hugely changed since SDK v13.0. With adding SDH to SDK, it provides SDH API to Enabling the SoftDevice and its event interrupt. Disabling the SoftDevice. Receiving…
- 13 Aug 2018
Bluetooth pairing vulnerability

PaKa

The Bluetooth SIG released an errata for the 4.2 and 5.0 versions of Bluetooth specification on July 23rd relating to a potential vulnerability with the pairing procedures. For Bluetooth low energy; this…
- 27 Jul 2018
Getting Started with the Thingy:52 and GCC/GDB

Daniel Veilleux

The Thingy:52 IoT Sensor Kit is a fancy development board that combines the nRF52832 SoC, a handful of sensors and user interface components, and a rechargeable battery. Although the Thingy is available…
- 20 Jul 2018