Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
How to clear/reset of the GPIO configuration before System ON mode 0

Hello,In normal condition, I use UART,pwm,spi an so on.Now I want to clear the configuration, and enter System ON mode.But I don't want to system reset. How should I do...
810 views

0 replies

Started over 10 years ago
by yao
Not Answered
multiple link using iPhone 0

Hi, everyone~ My goal is to collect data from 4 sensors simultaneously using iPhone. Now, my testing code for sensor nodes is working fine. It was built based on the...
- s120
- iphone
- multiple link
- beacon kit
- ble
- evaluation kit
- 110
- nrf51822
996 views

0 replies

Started over 10 years ago
by shuoyu_ding
Not Answered
Android and IOS bluetooth LE Communication through nRF Master Control Panel (BLE) 0

I am an android developer and I am using your nRF Master Control Panel (BLE) product as published on Google play. Below is the link to the app: play.google.com/.../details...
- android
2132 views

0 replies

Started over 10 years ago
by Emily
Not Answered
Do I need nrfgo to program nrf24lu1 on a custom PCB 0

I want to build a USB dongle, so I purchased the nrf24lu1+ development kit. However, in order to program the target board, it would seem that I need the nrfgo. Is this correct...
992 views

0 replies

Started over 10 years ago
by Sean
Not Answered
Can you provide the s120 guid that same as s110(nan-36)? 0

Can you provide the s120 guid that same as s110(nan-36)?
- nrf51822
505 views

0 replies

Started over 10 years ago
by hong tang

Recent in Nordic blog

How to build continuous integration and delivery process for embedded SW development

Yaniv Nis

If automated testing, continuous integration, and delivery processes are top of mind for you, but you are not sure how to start implementing it for embedded SW development - take a look at the following…
- 3 Oct 2017
Multiple channels in RTT

Krzysztof Zaraska

Segger RTT (Real-Time Terminal) supports multiple data channels. RTT Viewer uses channel 0 only, and implements multiple virtual terminals on top of this. The terminal can be switched by SEGGER_RTT_SetTerminal…
- 29 Sep 2017
6 Things to Know about Bluetooth Beacons

Rose Martin

Smartphones and tablets have revolutionized the manner in which people communicate with each other. Mobile applications with location-based features like Bluetooth beacons, WiFi, and GPS are helping people…
- 22 Sep 2017
Creating a Keil project for a Bluetooth Mesh example (Updated for 0.10.0)

Kristian Skordal

Introduction The recently released nRF5 SDK for Bluetooth Mesh does not provide Keil project files for its example projects. Fortunately, it's relatively easy to set up your own project from scratch.…
- 19 Sep 2017
Using millis() like in Arduino.

schef

Here are two simple functions to use when you want to use timestamps for time measurement. uint32_t millis(void) { return(app_timer_cnt_get() / 32.768); } and for comperison of current with given…
- 18 Sep 2017
Flashing nRF5x firmware using any dumb terminal program via standard serial COM port

Nguyen Hoan Hoang

There are times that we needed to flash the nRF5x series on a PC where the development software were not installed. The problem could be worst when network access is limited. With a HEX file on hand…
- 18 Sep 2017