Nordic DevZone

Recent and unreplied - Help your fellow developer and earn points!

Not Answered
nRF51 time of flight / distance 0

I'm interested in creating a time of flight algorithm and am trying to calculate what to expect for accuracy. Is it possible to get an IRQ from when the sync arrives at...
999 views

0 replies

Started over 10 years ago
by travisf
Not Answered
GPIOTE port event and pin events enable issue simultaneously 0

hi all , how to enable GPIOTE PORT and IN[n] event simultaneously ?(not same pin) i enable the GPIOTE to trigger interrupt event. one for the keyboard which need multiple...
- gpiote
- nrf51822
1738 views

0 replies

Started over 10 years ago
by steven
Not Answered
Cycle speed and cadence sensor data , even after stopping the cycle ? 0

Hi All, I am using nRF51422 with softdevice s310. And implementing Cycle speed and cadence receiver. most of the data processing is fine but i am facing one problem. ...
- nrf51422
- ant
713 views

0 replies

Started over 10 years ago
by Robin
Not Answered

Write and read back the FSR register failed 0

Hello Nordic Team, I have a problem with programming the nRF24LE1 chip. I am developing a small system, which consists of a uC STM32F4xx and a nRF24LE1 Radio Module. The...

894 views

0 replies

Started over 10 years ago
by MasterAlexei
Not Answered
SDK 6.0.0 OTA DFU iOS compatibility 0

Hi, I'd like to learn about the app compatibility for the new OTA DFU that ships with the new SDK 6.0.0 and S110 7.0.0. I am using a nRF51822 board and I've observed that...
- s110
- bootloader
- jlink
- keil
- dfu
- nrf51822
1333 views

0 replies

Started over 10 years ago
by Florin

Recent in Nordic blog

Nordic Semiconductor nRF51822 Firmware for Background Data Recording

scytulip

#Nordic Semiconductor nRF51822 Firmware for Background Data Recording Updating on https://github.com/scytulip/nrf51-back-rec Design Objective This firmware is designed for low-cost long-time low-power…
- 23 Oct 2014
Nordic nRF51822 ARM Cortex-M0 Development using emIDE

Hugh

Nordic nRF51822 ARM Cortex-M0 Development using emIDE To avoid the hefty charges with commercial compilers I tried emIDE with some success; here are the settings I used for the EV Kit Official emIDE…
- 22 Oct 2014
Beacon Kit - Mistake in Ref_Design_UG_v1.0

Salman

I connected the programming header as described in "nRF6930_Beacon_Ref_Design_UG_v1.0.pdf" 5.5.4 Programming interface. I was trying to program Beacon Kit but failed many times then I compared it with…
- 10 Oct 2014
SD card interfacing

Salman

Hi, I have written SD & SDHC card routine for reading, writing and erasing data from SD card. It used the hardware SPI of nRF51822. NOTE: 1)Define the PINs of SD card first before initialing. 2)Define…
- 10 Oct 2014
How different BLE packet types influence throughput

Stefan Birnir Sverrisson

There are several types of write operations, write request with authorization, write request without authorization and write command. You can see message sequence charts for those messages here and he…
- 9 Oct 2014
Measuring Lithium battery voltage with nRF51

Stefan Birnir Sverrisson

Here is an example of a hardware setup to measure the voltage on a Lithium battery with a voltage divider and a connected capacitor. The Lithium battery typically has a voltage range of 2.7 - 4.2 V and…
- 2 Oct 2014